Honeywell DR4300 manual Transmitter Power Out Wiring

Installation

2.6.3 Transmitter Power Out

Introduction

A recorder model is available that provides +24 Vdc power out to a transmitter.

Procedure

Refer to Figure 2-17and follow the procedure in Table 2-15to wire the transmitter power out.

Table 2-15 Transmitter Power Out Wiring

Step

Action

ATTENTION To avoid damaging the recorder, be sure that you install the power wires into the correct screw terminals as shown in Figure 2-9and Figure 2-10.

1Turn off the power to the recorder.

2Open the recorder door. Loosen the captive screw in the chart plate and swing the plate out.

3Locate the DC OUT terminal block on the Transmitter Power Module, located above the printed circuit assembly (PCA) for pen 1. (See Figure 2-17.)

4Run the output wires through the appropriate conduit hole (see Figure 2-7and Figure 2-8). Refer to Table 2-6for acceptable wire bundling.

5Strip 1/4-inch maximum of insulation from the end of each wire and form end to fit under a screw connection.

6Insert the wires under the appropriate screws for the transmitter power out as shown in the figure. Tighten the screws to secure the wires.

12/03 DR4300 Circular Chart Recorder Product Manual 43