Honeywell DR4300 manual Pen Parameters Set Up Group, Pen group prompts, Pen Parameter Definitions

Configuration, Startup, and Operation of Recorder with Display

4.3.8 Pen Parameters Set Up Group

Introduction

The functions in this group are used to configure the pen(s). The procedure for configuring each pen is the same. For a 2-pen recorder, the desired input channel is displayed on the left side of the operator interface.

Press FUNC key to select channel.

Pen group prompts

Table 4-6lists all the function prompts in the pen set up group.

Press the SET UP key until “PEN” appears in the lower display.

Press FUNC key to display parameters.

Table 4-6 Pen Parameter Definitions

Lower Display	Upper Display	Parameter
Prompt	Range of Setting	Definition
	or Selection
PEN IN		PEN INPUT—What do you want the pen to record?
	INP [factory setting]	INPUT—Records the input for given channel.
	REM1	REMOTE SWITCH 1 EVENT—Records the digital input
		event for given channel. (Event toggles pen between
		90 % and 95 % on chart.)
	REM2	REMOTE SWITCH 2 EVENT—Records the digital input
		event for given channel. (Event toggles pen between
		80 % and 85 % on chart.)
	OUT*	OUTPUT—Records the output for the channel.
	SP*	SETPOINT—Records setpoint for given channel.
		*Only selectable if hardware supports outputs and
		function prompt “CONTRL” in Control group is set to
		“ENAB” (enabled).
CHT HI	–999 to 9999	CHART HIGH RANGE VALUE—Enter a value that
	[factory setting = 780]	corresponds with the chart high range value for
		the pen. (This is the value that prints at the outer edge of
		the chart. If you had a range of 0 °C to –400 °C, –400
		would be the chart high range value.)
CHT LO	–999 to 9999	CHART RANGE LOW VALUE—Enter a value that
	[factory setting = 730]	corresponds with the chart low range value for the
		pen.

12/03 DR4300 Circular Chart Recorder Product Manual 89