Honeywell DR4300 Operator Interface on Recorder with Display and Keypad, Displays and indicators

DR4300 Circular Chart Recorder

4.2 Operator Interface on Recorder with Display and Keypad

Introduction

The DR4311, DR4312, DR4331 and DR4332 models include a display and keypad used to view real time values, change setpoints (if the recorder hardware supports outputs), and assign application-specific values to configuration parameters.

This subsection describes the operator interface, using the display and keypad to configure the recorder, and procedures for starting up and operating the recorder.

Displays and indicators

The indicators and text displayed let you see what is happening to your process and how the recorder is responding.

Figure 4-1is a view of the operator interface. A description of the displays and indicators is included.

Upper Display - four characters
Normal operation - Displays process variable
(PV) for the selected input channel.
Configuration mode - Displays selection or			Indicates temperature
parameter value.			units of PV on display.
Data displayed
is for input				SET
Channel 1 or 2	INP	1 2			FUNC
			FC	UP
Output relay 1 or 2	OUT	1 2		DISP	MAN
			MA
					AUTO
is ON, when lit.			R L

Lower Display - six characters
Normal operation - Displays selected	Indicates controller mode:
operating parameter label and value.	M = Manual
With totalization, shows totalizer value.	A = Automatic
Configuration mode - Displays Set Up group and
function parameters.	When either of the remote switches
	is set for SP2, or when NumSPs = TWO
	L = Setpoint 1 (SP) active
	R = Setpoint 2 (S2) active
	Otherwise, neither indicator	24278
	is used.

Figure 4-1 Operator Interface

72 DR4300 Circular Chart Recorder Product Manual 12/03