Honeywell DR4300 Timer Set Up Group, Timer group prompts, Timer Parameter Definitions, Period

Configuration, Startup, and Operation of Recorder with Display

4.3.14 Timer Set Up Group

Introduction

The timer option allows you to configure a timeout period and to select the timer start by either the keyboard (Increment or Decrement key) or Alarm 1. The optional digital input can also be configured to the start the timer. The timer display is selectable as either “time remaining” or “elapsed time”.

Alarm 2 is activated at the end of the timeout period. When the timer is enabled, it has exclusive control of the Alarm 2 relay; any previous Alarm 2 configuration is ignored. At timeout, the timer is ready to be activated again by whatever action has been configured. Relay 2 will remain energized until the timer is reset.

See Subsection 4.5.2.7 for operation of timer.

Timer group prompts

Table 4-12lists all the function prompts in the timer setup group and their definitions.

Press SET UP key until “TIMER” appears in the lower display.

Press FUNC key to display parameters.

Table 4-12 Timer Parameter Definitions

Lower Display	Upper Display		Parameter
Prompt	Range of Setting		Definition
	or Selection
TIMER	ENAB	TIMER - Use this to enable or disable the timer option.
	DIS [factory setting]
PERIOD	0:00 to 99:59	PERIOD - Configure the length of the timeout period (from
	[factory setting = 0]	0 to 99 hours, 59 minutes).
START	KEY [factory setting]	START - Select whether the Timer starts with the keyboard
	AL1	(Increment or Decrement key) or Alarm 1.
L DISP		L DISP - Select whether time remaining (TREM) or
		elapsed time (ET) is displayed for the timer option.r
		The time is shown on the lower display in hh:mm format
		along with a rotating “clock” character.
	TREM [factory setting]	Time remaining: If the “clock” rotation is clockwise, elapsed
	ET	time is indicated.
		Elased time: If the “clock” rotation is counterclockwise,
		time left is indicated.

12/03 DR4300 Circular Chart Recorder Product Manual 105