Honeywell DR4300 manual Display Parameter Set Up Group, Lockout group prompts, Blank

DR4300 Circular Chart Recorder

4.3.19 Display Parameter Set Up Group

Introduction

Using the BLANK function, the display can be set to turn off a configured number of seconds after the last press of any key. Pressing any key while the display is blank will restore it.

When the TOGGLE function is enabled, the pen currently driving the display will switch control to the other pen after a configured timeout period. If the other pen has its TOGGLE function enabled, it will switch back after its configured timeout period.

Lockout group prompts

Table 4-17lists the function prompt in the lock out set up group.

For a 2-pen recorder, the desired input channel is displayed on the left side of the operator interface. Press

FUNC to select channel.

Press SETUP key until “DSPLAY” appears in the lower display.

Press FUNC key to select the parameter.

Table 4-17 Display Parameter Definitions

Lower Display	Upper Display	Parameter
Prompt	Range of Setting	Definition
	or Selection
BLANK	OFF [factory setting]	BLANKING FUNCTION—Use this parameter to set
	2s	timeout period after which the display goes blank. OFF
	4s	disables the function.
	.
	.
	.
	30s
TOGGLE	OFF [factory setting]	TOGGLE FUNCTION—Use this parameter to set the
	2s	timeout period after which control the display is passed to
	4s	the other board (pen).
	.
	.
	.
	30s

114 DR4300 Circular Chart Recorder Product Manual 12/03