Honeywell DR4300 manual Configuration Tips

DR4300 Circular Chart Recorder

4.3.4 Configuration Tips

Introduction

Table 4-2contains tips that will help you enter the configuration data more quickly. If you can not change configuration parameters, check the status of the “LOCK” parameter (see Subsection 4.3.19).

		Table 4-2 Configuration Tips
Function									Tip
Displaying Groups
	Use the			SET UP			key to display the set up groups. The group titles are
	listed in this section in the order that they appear in the recorder.
Displaying Functions
	Use the			FUNC		key to display the individual function parameters under
	each group. The prompts are listed in the order of their appearance in each
	group.
Scrolling
	Holding the				SET UP			key in will scroll through the set up groups. However,
	when any set up group is displayed, you can scroll through the set up groups
	twice as fast using the ▲ or ▼key. When in any set up group, hold the
			key in to scroll through the prompts within that group.
		FUNC
Changing values quickly	When changing the value of a parameter, you can adjust a more significant
	digit in the upper display by holding in one key [▲] or [▼], and pressing the
	other [▲] or [▼] at the same time.
	• The adjustment will move one digit to the left.
	• Press the key again and you will move one more digit to the left.
Exiting Set Up mode
	To exit Set Up mode, press the								DISP	key.
	This returns the display to the same state it was in immediately preceding
	entry into the Set Up mode.
Timing out from	If you are in Set Up (configuration) mode and do not press any keys for one
Set Up mode	minute, the recorder will time out and revert to the mode and display that was
	being used prior to entry into Set Up mode.

78 DR4300 Circular Chart Recorder Product Manual 12/03