Honeywell DR4300 manual Rstabl, Cutoff

		Configuration, Startup, and Operation
		of Recorder with Display
Lower Display	Upper Display	Parameter
Prompt	Range of Setting	Definition
	or Selection
RSTABL		TOTALIZER RESETABLE—This parameter is used to specify
		whether and how the totalizer value can be reset.
	NO [factory setting]	NO—Totalizer value cannot be reset.
	KEY	KEY—Totalizer can be reset from the keypad by setting the
		“RESET” parameter to “YES”.
	REM1*	REM1—Totalizer will be reset when remote (external) switch
		(digital input 1) goes to ON (contact closure). This totalizer
		reset is independent of any set up of “REMSW1” in the remote
		switch set up group.
	REM2*	REM2—Totalizer will be reset when remote (external) switch
		(digital input 2) goes to ON (contact closure). This totalizer
		reset is independent of any set up of “REMSW2” in the remote
		switch set up group.
CUTOFF	0 % to 100 %	LOW CUTOFF VALUE—Input % of range below which the
		totalizer stops accumulating.

*Digital input card must be installed.

12/03 DR4300 Circular Chart Recorder Product Manual 93