Honeywell DR4300 manual Configuration Procedure, Step Operation Press Result

Configuration, Startup, and Operation of Recorder with Display

4.3.6 Configuration Procedure

Introduction

The configuration prompts are sequenced in a group/function hierarchy as shown in Figure 4-2.Once you have set the input switches in SW6 as described in Subsection 4.3.5, configure all the function parameters that are applicable for your recorder model and application. During configuration some function parameters will not be displayed if they do not apply to your application. For example, if you set the control group function “CONTRL” to “DIS”, disabling control, then no other control group prompts will be displayed.

To enter your selections or values, follow the procedure in Table 4-4and fill in the values or selections on the worksheet in Subsection 4.3.21. Keep this worksheet as a record of how your recorder was configured.

This procedure tells you the keys to press to get to any set up group (and any associated function parameters prompt).

Procedure

Follow the procedure listed in Table 4-4to access the set up groups and function prompts. If you have a 2-pen recorder, be sure to identify individual parameters for each pen and control loop as applicable.

Make sure lock set up group “LOCK” function is set to “NONE” or “CAL.” See Subsection 4.3.19.

Table 4-4 Configuration Procedure

Step Operation Press Result

1	Select Set Up mode			Upper Display
		SET
				SET	Lets you know you are in the
		UP
					configuration mode and a set up group
					title is being displayed in the lower
				Lower Display	display.
				INPUT	This is the first set up group title.
2	Select any set up group		• Successive presses of the				key will display
		SET				SET UP
				the other set up group titles shown in the prompt
		UP
				hierarchy in Figure 4-2.
			• You can also use the [▲] [▼] keys to scan the set up
				groups in both directions.
			• Stop at the set up group title which describes the
				group of parameters you want to configure. Then
				proceed to the next step.
3	Select a function parameter			Upper Display
		FUNC		xxxx	Shows the current value or selection for
					the first function prompt of the set up
					group that you have selected.
				Lower Display
				DECMAL	Shows the first function prompt within
					the selected set up group.
			Example displays show Input group function prompt
			“DECMAL” and the value selected.

12/03 DR4300 Circular Chart Recorder Product Manual 83