Product Profile, Set-Up, Operation | Fellowes PS70-2CD specs

Product Profile

This product is built to shred paper, staples, small paper clips, credit cards, CDs and DVDs. It is not built to take large paper clips, continuous forms, adhesive labels, transparencies, newspa- per, cardboard or any plastic other than credit cards. Using it for these purposes is likely to cause irreparable damage.

	Strip-cut	Confetti Cut
	PS70-2CD	PS80C-2
Sheet capacity*	15 sheets	10 sheets
Paper shred size	7/32"	5/32" x 1-1/2"
	(5.8 mm)	(3.9 x 38 mm)
CD/DVD capacity	1	1
Maximum paper width		9" (229 mm)
Recommended daily capacity	50-100 shredding passes
Maximum running time		20 minutes
Automatic cool-down period		30 minutes
Voltage	120 V / 60 Hz / 6.0 A

*Based on 20 lb., 8-1/2" x 11" (70gsm, A4) paper with shredder operating at rated voltage; heavier paper, high humidity, or other than rated voltage may reduce sheet capacity.

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING

While setting up shredder

•Check shredder for damage or defects; some paper particles in the basket are normal due to product testing and does not indicate a defect.

•If the cord is damaged do not replace cord or use the machine. Return machine for a replacement.

•Avoid touching exposed blades on underside of PS80C-2 confetti-cut shredder head.

•Plug power cord in an outlet that can easily be reached.

•Do not place shredder near or over a heat or water source.

While operating shredder

• Keep hands and hanging objects (jewelry, ties, loose clothing, long hair, etc.) away from paper entry.

• Keep children and pets away from the shredder.

When not in use

•Always turn off and unplug shredder

•Unplug before emptying basket

• Do not open shredder head: Danger of electric shock.

NOTE: Do not use flammable synthetic oil, petroleum-based products or aerosols of any kind on or near product at any time.

Set-Up

This shredder will only operate when used with the supplied basket. The supplied basket has a built-in safety feature which prevents the shredder from operating if used with any other basket or if improperly assembled.

•Position shredder head (6) over cabinet (2). Place shredder head on top of cabinet as shown in Figure A.

•Firmly push down on four corners of shredder head to “lock” shredder head into position.

•Push basket (3) into shredder cabinet as shown in Figure B. Basket must be pushed firmly, so edges of basket/cabinet are aligned properly.

NOTE: To disassemble, pull out basket, hold cabinet down by placing foot on bottom shelf, and firmly pull up on shredder head.

Operation

For convenience, your shredder is equipped with an automatic-start sensor (8). This means that when the control switch (5) is in the automatic [I] position, the shredder will start running when paper is fed into it. The shredder stops a few seconds after the paper has passed through. Because the sensor cannot tell the difference between paper and other objects, this feature can be a hazard, especially to children and pets. To avoid accidents, turn off the shredder as soon as you are finished. Unplug shredder if it will not be used for an extended period.

To shred

•Plug in shredder with control switch (5) in off [O] position

•Press control switch to automatic [I] position; cutting cylinders will run for 1-2 seconds to signal readiness and green light (4) will turn on.

PAPER

•Feed paper straight into entry (1), until the shredder automatically begins shredding; see Product Profile for limits on paper width, shreddable items, sheet capacity, etc.

•Shred for no more than 20 minutes; shredding longer will cause shredder to turn itself off for 30 minutes to cool down.

•Press control switch to off [O] position after cutting has stopped. With confetti-cut shred- der, cutting continues for several seconds after paper has gone through in order to clear shredded paper from cutting cylinders.

CDs and DVDs

•Hold CD or DVD at the edge and feed one at a time, straight into CD entry (10), releasing when shredding begins. Shredder will stop when CD has passed through entry. CDs will be shredded into small particles.

CAUTION: Do not hold CD or DVD with finger through the center ring while feeding into shredder.

In case of a paper jam, which may occur if the sheet capacity is exceeded or if paper is not put in straight, turn off and empty the basket if full. Then:

1)Press and hold control switch in reverse [R] position and attempt to back paper out of shredder.

2)If shredder jams in reverse mode, press control switch to automatic [I] position and attempt to continue shredding operation.

3)If shredder jams again, alternate control switch slowly between reverse [R] and auto- matic [I] positions to attempt to move jammed paper completely through shredder.

If you are unable to clear the jam using this method, turn off and unplug the shredder;
remove wastebasket from the cabinet and carefully remove any paper extending below
the cutting cylinders; insert wastebasket and repeat jam clearing procedure.	4
	4