BP7386, CF3400 Corsair 11/25/09 6:20 AM Page 6
2. Securely connect the fan motor white wire to the supply white (neutral) wire using wire connector supplied (Figure 4).
3. Securely connect the fan motor black wire to the supply black (hot) wire using wire connector supplied (Figure 4).
!WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
4. After connections have been made, separate the white and green wires from the black wires.
5. Carefully turn the wires upward and insert them up through the center opening of the ceiling cover and into the outlet box. Push the green and white wires into one side of the outlet box; push the black wires into the other side of the the outlet box.
6. Carefully slide the motor ring up the motor housing and position the ring so that the reverse switch slot in the ring is in the correct position (Figure 5).
NOTE: Careful not to scratch ceiling fan assembly while positioning the motor ring in place.
7. Secure the motor ring to the motor housing assembly using the three
REVERSE SWITCH
MOTOR RING 
MOTOR
HOUSING
Figure 5
!WARNING
To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket.
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
SUPPLY GROUND
BLACK
WIRES
WHITE WIRES
Blade Installation
!WARNING
To reduce the risk of personal injury, do not bend the blade flange when installing the blades, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.
1. With the fan suspended on the ceiling, position a blade on top of the ceiling fan blade flange by aligning the raised bosses into the blade mounting holes. Carefully position the blade medallion onto the blade by aligning its bosses with the blade holes. Install three #10- 32 x .75” oval head screws into the mounting holes of the medallion and securely tighten each screw (Figure 6). If using wooden blades, be very careful not to over tighten the blade screws.
NOTE: Screws for the wooden blades are shipped with the blades. Do not discard the blade packaging until you have located the screws.
NOTE: Recommend the blades screws be checked regularly for tightness.
Figure 4 | 6 | Model No.: CF3400 |