Echo SRM-225 specifications Long Term Storage Over 30 Days

Page 31

SRM-225

STORAGE

 

 

STORAGE

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Long Term Storage (Over 30 Days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Tighten all the screws and nuts.

6.Drain fuel tank completely. Press purge bulb 6-7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7.

a.Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

b.Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

c.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

X7722271109

31

© 2/2014 ECHO Inc.

Image 31
Contents Burn Hazard Operator’s ManualTable of Contents Servicing Information IntroductionAdditional or Replacement Manuals SafetyManual Safety Symbols and Important Information On / OFF International SymbolsPersonal Condition and Safety Equipment Repetitive Stress Injuries Vibration and ColdEquipment EPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeProduct Emission Durability Emission Compliance Period Description Description Contents Plastic Shield Installation AssemblyNylon Line Head Installation To Advance Trimmer Line Support Handle InstallationRemove Nylon Line Head Operation With Blades OperationBlade Selection Fuel Requirements FuelHandling Fuel After use Starting Cold EnginePurge Bulb Starting Warm EngineStopping Engine Move stop switch button a backward to Stop positionMaintenance Intervals MaintenanceSkill Levels Fuel Filter Air FilterCooling System Spark PlugSpark Arrestor Screen Exhaust SystemHigh Altitude Operation Carburetor AdjustmentExhaust Port Cleaning Engine Break-InLubrication Gear HousingDrive Shaft flex cable models Nylon Line Replacement Nylon Line Head Disassembly InstructionsSharpening Metal Blades Maintenance Engine Problem Troubleshooting Chart TroubleshootingLong Term Storage Over 30 Days StorageModel SpecificationsOWNER’S Responsibility Warranty StatementsWarranty Statements SRM-225 ECHO, Incorporated