Echo PB-250LN specifications Long Term Storage Over 30 Days

Page 26

STORAGE

PB-250LN

STORAGE

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Long Term Storage (Over 30 Days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Tighten all the screws and nuts.

6.Drain fuel tank completely. Press purge bulb 6 -7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7.

a.Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

b.Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

c.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

9.Remove blower pipe assembly from unit.

26

X7501183303

© 3/2013 ECHO Inc.

Image 26
Contents Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationInternational Symbols SafetyManual Safety Symbols and Important Information Personal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment EPA 2010 and Later and/or C.A.R.B. Tier Product Emission Durability Emission Compliance PeriodDescription Safety Decal Lists important safety precautions Contents Assembly Install Blower PipesOperation Remove Blower PipesHandling Fuel FuelFuel Requirements Starting Cold Engine Mixing InstructionsStarting Warm Engine Purge BulbStopping Engine Operating BlowerRead the Safety Section carefully Skill Levels MaintenanceMaintenance Intervals Air Filter Fuel FilterCooling System Cleaning GrillSpark Plug Exhaust System Cleaning Cylinder FinsExhaust Port Cleaning Spark Arrestor ScreenHigh Altitude Operation Carburetor AdjustmentEngine Break-In Start engine, run at idle for one minute Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage Over 30 DaysSpecifications ModelWarranty Statements OWNER’S ResponsibilityWarranty Statements PB-250LN PB-250LN