Echo CS-271T instruction manual Operation, Chain Lubricant, Cap indication, Start / Run

Page 16

Cap indication

Oil/fuel tanks are indicated by the following illustrations on the caps.

Oil tank cap

Fuel tank cap

CHAIN LUBRICANT

Proper lubrication of the chain while in operation reduces friction between the chain and the guide bar to a minimum and assures a longer service life.

Use bar and chain oil of high quality for this purpose.

Do not use used or reclaimed oil to avoid various oiler problems.

Use ECHO bar and chain oil.

When ECHO bar and chain oil is not available: Use motor oil, etc.

Use bar and chain oil of the following grades: SAE No. 30....... in summer

SAE No. 10....... in winter or when cutting resinous trees

When refueling, also refill chain oil.

OPERATION

Chain brake

Start / Run

Ignition switch

Purge pump

Choke Choke control knob

WARNING

After choke control knob is turned and then knob is returned to original position, throttle remains a little open (latch condition).

If engine is started in this latch condition, chain starts to turn. Do not start engine before chain brake is activated.

CAUTION

After starting the engine, immediately squeeze and release throttle trigger for disengaging throttle latch and returning engine to idle, and pull front hand guard towards the operator immediately. (Chain brake unlocked position)

Never use throttle latch for cutting.

Use the chain brake only in starting or in emergencies.

Starter handle

Unlock chain brake

CS-271T

14

Image 16
Contents CS-271T Copyright 2013 All Rights Reserved Kickback Safety Precautions for Chain Saw Users Rules for Safe OperationOther Safety Precautions Contents Symbols and SignsSymbol Form DecalsPacking List Warranty sheetEcho chain saw Nomenclature of Parts X505-002310 X505-002062 Part Number X524-004650Chain tension adjuster Device to adjust chain tension Operator Safety Correct USE of Chain Brake Spark Arrestor MufflerPreparation for USE Guide BAR and SAW Chain INSTALLATION/REMOVALKick Guard to BAR Instructions Adjusting Chain Tension Fuel and Lubricant Fuel StatementHandling Fuel Emission DataEmission Control Operation Chain LubricantCap indication Start / RunWhen the Engine is Cold When the Engine is WarmRunning StoppingChecking Chain Tension Chain Lubrication TestCutting Instruction GeneralFelling the Tree Limbing Testing the Brake Chain Brake OperationChain brake function Chain brake unlockAutomatic Chain Brake Stop the engineLow-kickback Replacement guide bars Chain and Guide BAR CombinationGuide BAR SAW ChainMaintenance Intervals Maintenance and CareSkill Levels Carburetor Adjustment High Altitude OperationAIR Filter Check Fuel SystemSpark Plug Fuel FilterAdjusting screw Decrease Increase SprocketCylinder Fins Muffler Spark ArrestorSetting the SAW Chain Setting SAW ChainCS-271T Troubleshooting Problem Cause RemedyTechnical Data Storage After USEWarranty Statements ExceptionsPurchased Repair PARTS, Short Blocks and Accessories Memorandum C26411001001/C26411999999 C26312001001/C26312999999