Echo CS-271T instruction manual AIR Filter, Check Fuel System, Spark Plug, Fuel Filter, OIL Filter

Page 27

Air filter

Air cleaner cover

Cleaner cover knob

AIR FILTER

Check before every use.

Close choke ().

Turn cleaner cover knob counterclockwise by hand and remove air cleaner cover and air filter.

Brush off dust lightly, or clean with compressed air, or replace the air filter.

Reinstall air filter and cover.

CHECK FUEL SYSTEM

Check before every use.

After refueling, make sure fuel does not leak from around fuel pipe, fuel grommet or fuel tank cap.

In case of fuel leakage there is a danger of fire. Stop using the machine immediately and request your dealer to inspect or replace.

0.65 mm (0.026 in.)

SPARK PLUG

Check periodically.

The standard spark gap is 0.65 mm (0.026 in.).

Correct the spark gap if it is wider or narrower than the standard gap.

Fastening torque: 15 to 17 N·m

(130 to 145 in. lb.).

Fuel tank cap

Fuel filter

FUEL FILTER

Check periodically.

Do not allow dust to enter fuel tank.

A clogged filter will cause difficulty in starting engine or abnormalities in engine performance.

Pull the fuel filter out through fuel inlet port with a piece of steel wire or the like.

When the filter is dirty, replace it.

When the inside of the fuel tank is dirty, rinsing the tank out with gasoline can clean it.

Oil tank cap

Oil filter

OIL FILTER

Check periodically.

Do not allow dust to enter into oil tank.

A clogged oil filter will affect the normal lubricating system.

Pull it out through oil filling hole with a piece of steel wire or the like.

If the filter is dirty, wash it in gasoline or replace it.

When the inside of the tank gets dirty, rinsing the tank out with gasoline can clean it.

25

CS-271T

Image 27
Contents CS-271T Copyright 2013 All Rights Reserved Rules for Safe Operation Kickback Safety Precautions for Chain Saw UsersOther Safety Precautions Symbols and Signs ContentsDecals Symbol FormWarranty sheet Packing ListEcho chain saw X505-002310 X505-002062 Part Number X524-004650 Nomenclature of PartsChain tension adjuster Device to adjust chain tension Operator Safety Spark Arrestor Muffler Correct USE of Chain BrakeGuide BAR and SAW Chain INSTALLATION/REMOVAL Preparation for USEKick Guard to BAR Instructions Adjusting Chain Tension Fuel Statement Fuel and LubricantEmission Data Handling FuelEmission Control Start / Run OperationChain Lubricant Cap indicationWhen the Engine is Warm When the Engine is ColdChain Lubrication Test RunningStopping Checking Chain TensionGeneral Cutting InstructionFelling the Tree Limbing Chain brake unlock Testing the BrakeChain Brake Operation Chain brake functionStop the engine Automatic Chain BrakeSAW Chain Low-kickback Replacement guide barsChain and Guide BAR Combination Guide BARMaintenance and Care Maintenance IntervalsSkill Levels High Altitude Operation Carburetor AdjustmentFuel Filter AIR FilterCheck Fuel System Spark PlugMuffler Spark Arrestor Adjusting screw Decrease IncreaseSprocket Cylinder FinsSetting SAW Chain Setting the SAW ChainCS-271T Problem Cause Remedy TroubleshootingStorage After USE Technical DataExceptions Warranty StatementsPurchased Repair PARTS, Short Blocks and Accessories Memorandum C26411001001/C26411999999 C26312001001/C26312999999