Echo PPF-280 manual Power PrunerTM 19 Operators Manual, Starting warm engine, Stopping engine

Page 19

Power PrunerTM 19 Operator's Manual

starting warm engine

The starting procedure is the same as Cold Start except DO NOT close the choke, and do not depress throttle trigger to wide open position.

WARNING

The attachment should not move at idle, otherwise serious personal injury may result.

NOTE

If attachment moves, readjust carburetor according to “Carburetor Adjustment” instructions in this manual or see your ECHO Dealer.

1.Stop Switch

Move stop switch (A) forward away from the STOP position.

2.Purge Bulb

Pump purge bulb (C) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.

3.Recoil Starter

Lay the unit on a flat, clear area and pull the recoil starter handle

(D) until the engine fires.

NOTE

If engine does not start after 5 pulls, use Cold Start Procedure.

A

CD

D

stopping engine

1.Throttle

Release throttle and allow engine to return to idle before shutting engine off.

2.Stop Switch

Move stop switch (A) backward to STOP position.

WARNING

A

If engine does not stop when stop switch is moved to STOP posi- tion, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop switch before using pruner again.

Image 19

Contents Power PrunerTM Operators manual Safety manualTable of Contents IntroductionSafety Manual Safety Symbols and Important Information Power Pruner TM Operator s ManualInternational symbols Personal condition and safety equipment Read the Manuals Repetitive Stress InjuriesKeep a Solid Stance KickbackGuide Bar and Saw Chain EquipmentHot Decal near muffler Emission Control exhaust & evaporativeDescription EPA 2010 and Later and/or C.A.R.B. TierPower Pruner TM Operator s Manual Page Cutting attachment to drive shaft installation Power PrunerTM Operators ManualContents AssemblyDrive shaft / power head Throttle linkage and ignition leads Power PrunerTM 13 Operators ManualTo Adjust Saw Chain Tension Saw chain tension adjustmentFuel OperationFuel Requirements Handling Fuel Lubricating the guide bar and saw chain Adjusting automatic oilerAutomatic Oiling System Purge Bulb Starting cold engineStarting warm engine Power PrunerTM 19 Operators ManualStopping engine Pruning techniques Maintenance intervals MaintenanceSkill levels Dual Layer Air Filter Air filterFuel filter Foam Pre-filterSpark plug Cooling system cleaningSpark Arrestor Screen Exhaust systemExhaust Port Cleaning Power PrunerTM 25 Operators ManualEngine Break-In Carburetor adjustmentHigh Altitude Operation Lubrication Power PrunerTM 27 Operators ManualGuide bar and saw chain replacement Guide Bar Replacement / InstallationGuide Bar Cover Cleaning Power PrunerTM 29 Operators Manual PPF-280 Power Pruner B&C CombinationsFiling standard saw chain Internal engine problem See your echo dealer TroubleshootingStorage Long Term Storage over 30 daysModel PPF-280 SpecificationsExceptions Warranty Statements99922201032 12/03/09 99922201033 Power PrunerTM Operators Manual Page Power PrunerTM Operators Manual Echo consumer product support ServiceWarranty registration Additional or replacement manuals Servicing Information parts/serial number