6
Keep A Solid Stance
•Maintain footing and balance at all times. Do not stand on slippery, uneven or unstable surfaces. Do not work in odd positions or on ladders. Do not overreach.
•Operate the Power PrunerTM only from the ground or out of an ap- proved bucket lift.
•Always evaluate the branches to be pruned for hazards such as loose dead branches which may fall and strike the operator or helpers. Remove hazards before pruning.
•Plan retreat path from falling objects.
•Cut branches bounce when striking ground.
•Check that shoulder harness is adjusted for safe, comfortable opera- tion. See picture at right for proper adjustment.
•Turn the Power PrunerTM off when moving from tree to tree.
•Avoid any contact with saw chain.
Avoid Hot Surfaces
•Keep exhaust area clear of flammable debris. Avoid contact during and immediately after operation.
kickback
warning
Kickback can lead to dangerous loss of control of the Power PrunerTM and result in serious injury to the operator
or any one standing close by. Hold the Power PrunerTM firmly with both hands with thumbs and fingers encircling
the front and rear handles. Be aware of the down and outward path the pruner will take after the cut is made.
Kickback may occur when the moving saw chain at the nose or tip of the guide bar touches an object, or when the wood closes in and pinches the saw chain in the cut. In some cases this may cause a
With a basic understanding of kickback, you can reduce or eliminate the element of surprise which contributes to accidents.
Avoid contact of the guide bar tip with any object while the saw chain is moving.
Cut only wood. Avoid striking concrete, metal, wire, or other obstruc- tions which could cause kickback or damage to the saw chain.
If the saw chain does strike a foreign object, immediately stop the en- gine, inspect and repair the Power PrunerTM if necessary.