Echo PPF-280 manual Power Pruner TM Operator s Manual

Page 9

Power PrunerTM	9
Operator's Manual

9 8

7

10

6

11

5

4

12

3 2

1

13

1.POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Starter.

2.REAR HANDLE ASSEMBLY - Rear (right hand) handle.

3.THROTTLE TRIGGER LOCKOUT - This lever must be held during starting. Operation of the throttle trigger is prevented unless throttle trigger lockout lever is engaged.

4.STOP SWITCH - Mounted on top of rear handle assembly. Move switch forward to run, back to stop.

5.STRAP HOOK - Used to secure unit to shoulder harness.

6.FRONT HANDLE - Cushioned grip for left hand.

7.CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.

8.AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.

9.GUIDE BAR - 305 mm (12 in.) guide bar.

10.SAW CHAIN - 90, 9.53mm (3/8 inch) pitch, 0.043 gauge low profile saw chain. Runs approximately 609.6 m/min.

(2000 ft/min) at full throttle.

11.CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, acceler- ate and lower saw chain into branch.

Image 9

Contents Power PrunerTM Table of Contents Safety manualIntroduction Operators manualPower Pruner TM Operator s Manual Safety Manual Safety Symbols and Important InformationInternational symbols Personal condition and safety equipment Read the Manuals Repetitive Stress InjuriesKeep a Solid Stance KickbackGuide Bar and Saw Chain EquipmentDescription Emission Control exhaust & evaporativeEPA 2010 and Later and/or C.A.R.B. Tier Hot Decal near mufflerPower Pruner TM Operator s Manual Page Contents Power PrunerTM Operators ManualAssembly Cutting attachment to drive shaft installationDrive shaft / power head Throttle linkage and ignition leads Power PrunerTM 13 Operators ManualTo Adjust Saw Chain Tension Saw chain tension adjustmentOperation FuelFuel Requirements Handling Fuel Adjusting automatic oiler Lubricating the guide bar and saw chainAutomatic Oiling System Purge Bulb Starting cold enginePower PrunerTM 19 Operators Manual Starting warm engineStopping engine Pruning techniques Maintenance Maintenance intervalsSkill levels Fuel filter Air filterFoam Pre-filter Dual Layer Air FilterSpark plug Cooling system cleaningSpark Arrestor Screen Exhaust systemExhaust Port Cleaning Power PrunerTM 25 Operators ManualCarburetor adjustment Engine Break-InHigh Altitude Operation Guide bar and saw chain replacement Power PrunerTM 27 Operators ManualGuide Bar Replacement / Installation LubricationGuide Bar Cover Cleaning Power PrunerTM 29 Operators Manual PPF-280 Power Pruner B&C CombinationsFiling standard saw chain Internal engine problem See your echo dealer TroubleshootingStorage Long Term Storage over 30 daysModel PPF-280 SpecificationsExceptions Warranty Statements99922201032 12/03/09 99922201033 Power PrunerTM Operators Manual Page Power PrunerTM Operators Manual Warranty registration Additional or replacement manuals ServiceServicing Information parts/serial number Echo consumer product support