Dixon ZTR 5601, ZTR 5422, ZTR 5502 manual Specifications

SPECIFICATIONS

Model ZTR 5422

CHASSIS:

BODY:

11 GA - rectangular tube

Two piece - made of rotational molded polyethylene. Front body contains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.

SEAT:	Designed for operator comfort by use of high density closed cell foam padded
	back and arm rests. Seat is adjustable fore and aft.
MOWER DECK:	13 GA stamped steel construction
	3 blades combine for a 42" cut width
	Cut height approximately 1 .5" to 4.5" via 7 position lift handle
BLADE DRIVE:	Electric clutch
DRIVE SYSTEM:	Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
	hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
	enclosed HydroGear gearbox.
ENGINE:	1 6 HP Kohler Magnum, Vertical Crankshaft, 4-Cycle, Air Cooled, Gasoline, Twin
	CylinderOpposed, Aluminum Crankcase, Removable Cast Iron Cylinder Barrels,
	Electronic Ignition, Full Pressure Lubrication.

STARTING SYSTEM:

TIRES:

RECOMMENDED TIRE PRESSURE: -^

CAPACITIES:

DIMENSIONS:

N

Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.

Front	11 X 4 X 5 smooth profile
Rear	18 X 9.5 X 8 Multi Trac
Front	16-21 Ibs.
Rear	8 - 1 4 Ibs,

Fuel - 4.8 gallons total (dual tanks)

Hydrostat oil tank - 3 quart with in-line 10 micron filter

Hydrostat oil recommendation, refer to page 37

Engine - 2 qts. SAE 30 (with filter)

Width	51"
Height	45"	:	.
. Length	72"
Weight	61 5 Ibs.

NOTE: Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 8