Dixon ZTR 5502, ZTR 5422, ZTR 5601 manual Chassis

	SPECIFICATIONS
		Model ZTR 5601
CHASSIS:	11 GA - rectangular tube
BODY:	Two piece - made of rotational molded polyethylene. Front body contains
	access panels for battery service and engine to mower deck belt removal. Rear
	body tilts up to allow service on the entire drive system.
SEAT:	Ergonomically designed for operator comfort by use of high density closed cell
	foam, contoured back rest and arm rests. Seat is adjustable fore and aft.
MOWER DECK:	10 GA stamped steel construction
	3 blades combine for 60" cut width
	Cut height approximately 1" to 4" via 8 position lift handle
BLADE DRIVE:	Electric clutch
DRIVE SYSTEM:	Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
	hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
	enclosed HydroGear gearbox.
ENGINE:	22 HP Kohler Command, 4-Cycle, Twin Cylinder, V-Configuration, Overhead
	Valve, Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head and Crankcase with
	Cast Iron Liners, Oil Cooler.
STARTING SYSTEM:	Electric by key switch operation with safety interlocks on parking brake and blade
	drive clutch.
TIRES:	Front	1 1 X 4 X 5 ribbed tread
	Rear	20 X 10X8 Muiti Trac
RECOMMENDED	Front	16-21 Ibs.
TIRE PRESSURE: -	Rear	8- 14 Ibs.
CAPACITIES:	Fuel - 4.8 gallons total (dual tanks)
	Hydrostat oil tank - 3 quart with in-line 10 micron filter
	Hydrostat oil recommendation, refer to page 37
	Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS:	Width	72"
	Height	45"
	Length	72"
	Weight	685 Ibs.
NOTE:	Additional information provided in service instructions under the individual
	component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 10