Marantz CDR510 manual Troubleshooting

Page 54

TROUBLESHOOTING

Should faults occur, it is in many cases not necessary to consult your dealer or technical service department. On the basis of the following checks, you will be able to rectify a number of conditions yourself without difficulty. If the condition cannot be remedied after the following check, please consult your dealer or contact D & M Professional at 866 405 2154.

No Power

•check power cord connections

•switch POWER off then immediately back on

Recording does not contain tracks

•check that AUTO TRACK is ON

•check if there is 2.7 seconds of silence (analog)

•check that the digital source conforms to the SPDIF or IEC-958-II standard

•is source a DVD video disc (DVD discs do not contain track information)

No Sound

•check audio connections

•if using an amplifier or receiver,

•check amplifier or receiver settings

•check that a signal is present

•try a different amplifier or receiver

Sound distorted

•check that analog output is not connected to a PHONE input

•check that disc is not defective (try another)

Recording distorted

•check recording level

•try another disc

XLR input too high or too low

•adjust record level

•adjust TRIM

Play will not start

•check that the label of the CD is facing up

•clean the disc

•check that disc is not defective (try another)

Remote control does not work

•check that EXT / INT (IR) switch on rear is at INT

•check drive selection (CDR or CD)

•point the IR remote control directly at the IR receiver

•check or replace batteries

Will not record

•check input source selection (INPUT button selection matches input source connected)

•check that disc is not an audio disc (WRONG DISC display)

•clean the disc

•check if CD-R/RW is an unfinalized disc

•try another disc

•text memory full (MEMORY FULL/FINALIZE CD display Erase CD Text for other disc(s) or finalize other disc(s) to obtain memory space.)

DIGI flashing in display

•check digital cable connections

•try a different cable

•check that the output of the digital source con- forms to the SPDIF or IEC-958-II standard

OPTI flashing in display

•check optical connections

•try a different connector

•check that the output of the digital source con- forms to the SPDIF or IEC-958-II standard

DIGI flashing in display

•check digital cable connections

•try a different cable

•check that the output of the digital source con- forms to the SPDIF or IEC-958-II standard

Disc playback quality on other players is poor

•check disc quality

•check that discs are compatible with 1X recording

•try 'Music' (consumer) blank discs

•if using 80 minute discs, try a 74 minute disc (they provide a wider recording area and thus less chance for error)

CD Text appears on CD drive but not CDR drive

•check disc (The CDR drive does not display CD Text on 'hybrid' CDs that contain audio and data together on the disc.)

- 54 -

Page 53 Page 55
Image 54
Page 53 Page 55
Contents Recordable No USER-SERVICEABLE Parts Inside Refer Servicing to Qualified Service PersonnelRisk of Electric Shock Copyright CE marking only EU versionEquipment mains working system CE marking English Precautions installationPrecautions connection FrançaisImportant Safety Instructions Table of Contents Introduction Fast forward search buttonAudio output CD drive FeaturesAudio input CDR drive Audio output CDR drivePackage contents Connections basic Remote batteriesDual mode How to Play back Changer modeTo select Changer mode To select Dual modeTo Stop Play back featuresTo Pause To display timesHow to Record To record from the CD driveInternal REC modes Digital AnalogXLR RCACD Text Copy protectionAdditional Recording Information Changer Mode Dual ModeONE Touch Record Record mode REC LEVEL/SELECTControl Press Record 25, 26. Album buttons Plug stereo headphones in hereForward button Headphone jackTime label DisplayTrack label Step labelManual label DIG 17. Digi labelSync label Analog 20. Analog labelCD Analog OUT jacks Controls and Connections rearCD drive outputs CD DIG OUT jackAnalog in / OUT Remote RC5 in / OUT Door OPEN/CLOSE ChangerStop button Cancel buttonPause button Display buttonSource button Enter buttonMenu mode CD-R/RWTo make a menu change ALL Text Auto Track OFF How to turn Auto Track on or OFFAuto Track Auto Track onAuto Stop OFF How to turn Auto Stop on or OFFAuto Stop Auto Stop onREC Balance Text ON/OFFHow to turn SRC on or OFF SRCHow to turn Copy ON, OFF or to HCO Copy OFFCopy on How to adjust the Pitch menu control How to turn the Pitch on or OFFPitch How to turn Auto CUE on or OFF How to adjust the Auto CUE LevelAuto CUE Level How to set the Play Mode How to set Single PlayHow to set END Warning REC EXT MAN Recording modesREC EXT Disc Minute TrackREC MP3 Disc Record FastREC Listen Make CDMP3 playback and recording How to turn Auto MP3LOAD on or offMP3 Auto MP3 LoadMP3 Load How to MP3 LoadHow to record MP3 AppearsPlaying Albums in sequence MP3 Album/file structureMP3 File Playback Selecting Albums and files for play backTo edit a program How to Program tracksClearing a program To program for recordingFinalize CD Alternating with Press Enter Display messages Auto TrackAbout Compact Discs Which discs to usePage Commands Requesting Status RS-232C controlRS-232C specifications Status changes automatically transmittedControl commands Status data transmissionRC-5 Codes Troubleshooting Playback Specifications GeneralCD Recorder Recording analog Input /OutputLimited Warranty Marantz is a registered trademark 2003/8

CDR510 specifications

The Marantz CDR510 is a highly regarded CD recorder that combines advanced technology with user-friendly features for audiophiles and music enthusiasts. It gained recognition for its ability to deliver exceptional sound quality while providing a range of functionalities that cater to both recording and playback needs.

One of the standout characteristics of the CDR510 is its dual functionality as both a CD recorder and a CD player. This versatility allows users to easily record their favorite music from various sources including vinyl records, cassette tapes, and other audio devices directly onto CD-R or CD-RW discs. The inclusion of a high-quality analog-to-digital converter ensures that recordings capture the nuanced details of the original audio source, resulting in an accurate and high-fidelity reproduction.

The CDR510 also features a digital input/output, allowing for greater connectivity options. Users can connect external sources such as digital audio players or computers via optical or coaxial connections, making it a flexible choice for those looking to integrate this recorder into their existing audio setups. Enhanced functionality is provided through a variety of playback modes, including repeat and shuffle, allowing users to customize their listening experience.

Another notable technology in the CDR510 is its built-in sampling rate converter, which enables the recording of audio from sources with different sample rates, ensuring compatibility and high-quality playback regardless of the origin of the material. The device supports CD-R and CD-RW formats, providing users with the flexibility to choose between permanent and erasable recording options.

The user interface of the Marantz CDR510 is intuitive, featuring a clear display that provides essential information about the current track, elapsed time, and remaining time, making navigation straightforward for users. The front panel controls are well laid out, ensuring ease of access to various functions, from recording to editing tracks.

Overall, the Marantz CDR510 is an exceptional CD recorder that embodies the brand’s commitment to audio quality and user satisfaction. With a combination of versatile recording capabilities, high-quality audio processing, and user-friendly design, it remains a popular choice for those who value both music preservation and playback excellence. Whether you're looking to archive your music collection or create custom mixes, the CDR510 provides a reliable and high-performance solution.
Top Page Image Contents