Dixon ZTR 2700, 12828-0603 manual Hydrostatic Pumps, Hydrostat Drive Belt Replacement Procedure

Page 34

CARE AND MAINTENANCE

HYDROSTATIC PUMPS:

Before each use, check to be sure that the cooling fins of the hydrostatic pumps are clean. Excessive accumulation of oil, dirt, or trash may cause the pumps to overheat.

NEVER WASH ACROSS TOP OF RESERVOIR WITH WATER OR STEAM. Fill reservoir as required per the maintenance schedule listed in this book.

HYDROSTAT DRIVE BELT REPLACEMENT PROCEDURE:

To remove hydrostat pump drive belt:

(The hydrostat pump drive is equipped with a spring loaded belt take-up).

1. Raise seat. (See instructions on Page 25).

2. Remove hold down bolts from belt cover. Remove belt cover.

3. Rotate the spring loaded take-up idler towards the left hand hydro pump to provide belt slack for removal.

4. Remove belt.

To install hydrostat pump drive belt:

1.Rotate the spring loaded take-up idler towards the left hand hydro pump.

2. Install belt per diagram.

3. Re-attach belt cover.

4. Return the seat to the operating position.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Model Important Read Carefully D E Safety Safety Alert Symbol General Operation General Operation Slope Operation On it, do not mow itSlope Operation Do notI L D R E N R V I C E Service Dixon Limited Warranty Policy Commercial Models 2700 Series Specifications ModelControls Control LeversMower Deck CUT Height Lift Lever Parking BrakeA T Choke Control Lever Mower Blade SwitchIgnition Switch Throttle Control LeverControls Operation Instructions Before Operating MowerTesting of Safety Interlock Systems Interlock Switch Test Starting Instructions Stopping InstructionsMowing Instructions Grass Height and Cutting Suggestions To Lift Seat SpringsTo Free Wheel Machine Unlock Transmission Care and Maintenance Maintenance ScheduleEngine BatteryTires Mower Blades BeltsLubrication Checking & Replenishing OIL in Hydrostatic Transmission Dirt or water in oil can ruin Hydrostatic transmissionsParking Brake Adjustment Headlight Adjustment Hydrostat Drive Belt Replacement Procedure Hydrostatic PumpsSteering Control Adjustments To adjust neutralSteering Control Adjustments To adjust steering control leversSteering Control Adjustments Leveling the Deck ZTR Model Kawasaki AIR and OIL FilterTroubleshooting Engine Backfires Electrical Systems Owner F O R M a T I O N ZTRMowers
Top Page Image Contents