Dixon 13090-0700, ZTR 6022 manual Leveling the Deck

Page 33

CARE AND MAINTENANCE

LEVELING THE DECK:

The deck comes from the manufacturer pre-leveled. If the deck does appear to be cutting unlevel follow this procedure.

1. Set all tire pressure to correct specifications (see page 23).

2. Place machine on a level slab of concrete.

3. Move blades by hand so all the blades are pointed in the same direction (see diagram on page 34). Measure from the blade tip (beveled edge) to the ground, all three blades. If there is more than a 3/16" difference from one side to the other, the deck should be leveled.

4. Remove the clevis pin from the rear of the lift spring rod, on the high side. The lift spring rod is two parts-one threaded into the other. Turn the lift spring rod counter- clockwise 2 turns. Reassemble clevis pin and remeasure. Repeat as required to achieve a difference of no more than 3/16" from one side to the other.

5, If the deck is level side to side but high or low at the center blade, both lift spring rods must be adjusted equal amounts. Shortening the lift spring rods will bring the center blade up and lengthening the lift spring rods will let the center blade down.

Lift Spring Rod

Lift Spring

Clevis Pin

Tension Adjust Bolt

Page 33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents 6000 Important Read Carefully Index Safety Safety Alert Symbol General Operation Do not Slope OperationChildren Service Models6000&7000 Dixon Limited WARRANTYPOLICY- CommercialmodelsSeries Forward Mount SpecificationsSeat Adjustment Instructions Control Locations ControlsParking Brake To GO Backward Blade Drive Circuit BreakerMower Deck CUT Height Lift Lever Towing Operation InstructionsTesting of Safety Interlock Systems Unlock Transmission Starting Instructions Cold EngineEngine has been operated Starting InstructionsGrass Height Suggestions Discharge chuteMaintenance Schedule Care and MaintenanceEngine Belts Mower BladesChecking & Replenishing OIL in Hydrostatic Transmission LubricationParking Brake Adjustment Hydrostatic TransmissionScalper Roller Bolts Hydrostat Drive Belt Tension Adjustment Steering Control Adjustments Steering Control Adjustments Lower and Reattach the Deck see diagram-page Down Hanger Engagedposition Changing the Fluid in Deck Drive Gearbox Checking Deck Drive Gearbox Fluid LevelLeveling the Deck Deck Spindle Belt Diagram Standard Service Parts List Model ZTRKohler AIR and OIL Filter Part Numbers Engine Wont Turn Over TroubleshootingEngine Idles Poorly Page Date OIL Changed Date Engine Tuned Owner InformationSeries 6022
Top Page Image Contents