Epson U230 Drawer Kick-out Connector, Drawer Kick-out Specifications, Limitations, Confidential

Confidential

Drawer Kick-out Connector

The signal specified by the ESC p command is output to this connector. The host can check the status of input signal by the following commands.

•DLE EOT

•GS r

•GS a (ASB)

Drawer Kick-out Specifications

Item		Specifications
Pin assignment		See “Drawer kick-out connector pin assignment”
		table
Model	Printer side	Molex 52018-6615 (or equivalent)
	User side	6-position 6-contact (RJ12 telephone jack)
Drawer kick drive signal	Output voltage	Approx. 24 V
	Output current	1A or less
	Output waveform

		t1⋅	2 ms	t2⋅ 2 ms
		Outputs the waveforms in the figure “Drawer
		circuitry”. (The ESC p command specifies ON
		time t1 and OFF time t2.)
Drawer open/close signal	Input signal level	"L"= 0 V
	(connector pin )	"H"= 2Å`5 V
Connector appearance

1

6

Limitations

❏The resistance of the drawer kick-out solenoid must not be less than that specified (24 Ω). Otherwisee, an overcurrent could damage the solenoid.

❏Drawer kick-out cable must be shielded.

Appendix A-8Specifications