SAFETY
Rollover Protection System (ROPS)
The ROPS increases the basic weight of the unit by 73 lbs/33 kg.
•Do not use ROPS as a lifting, attaching or anchoring point.
•Do not use ROPS for wrecking or towing.
•Do not exceed Max GVW: 2822 lbs/1283 kg.
•Read machine’s operator manual before each use.
•Securely fasten the seat belt if the unit has a ROPS.
•Where possible, avoid operating the unit near ditches, embankments and holes.
•Reduce speed when turning, crossing slopes and on rough, slick or muddy surfaces.
•Stay off slopes too steep for safe operation.
•Watch where you are going, especially at row ends, on roads and around trees.
•Do not permit others to ride.
•Operate the mower smoothly - no jerky turns, starts or stops.
•When mower is stopped, set brakes securely and use park brake.
•If any part of ROPS is damaged, the entire ROPS must be replaced.
•Check all bolts including seat belt for correct torque before each use.
•Check ROPS structure for damage before each use.
•ROPS bar is NOT intended for use in sub zero temperatures.
WARNING!
The rollover protection system's capabilities may be impaired by damage if the mower is overturned or if alteration to the ROPS occurs. If these conditions take place, the total structure MUST be replaced.
WARNING!
This mower is equipped with an internal combustion engine and should not be used on or near any unimproved forested, bush covered or grassy lands unless the engine's system is equipped with a spark arrester meeting applicable local or state laws (if any).
WARNING!
The engine and the exhaust system become very hot during operation.
There is risk for burns if touched.
Allow engine and exhaust system to cool at least two (2) minutes before refueling.
Spark Arrestors
A spark arrester is standard equipment on the unit and is attached to the engine muffler. Clean the interior screen regularly, depending on usage and conditions.
To clean, remove the clamp securing the tail pipe. Remove the tail pipe and slide the spark arrestor screen out of the muffler. Clean carbon from the screen with a soft brush or cloth.
Replace screen and reattach the tail pipe, orienting the tail pipe either horizontally or upwards, away from grassy surfaces.
Regularly clean spark arrestor screen
17