Dixon 966516702, 966516601, 966516602 Weak Battery, Jumper Cables, To remove cables, reverse order

Page 32

OPERATION

Weak Battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

IMPORTANT INFORMATION

 

The mower is equipped with a 12-volt negative

 

grounded system. The other vehicle must also

 

be a 12-volt negative grounded system. Do not

 

use the mower to start other vehicles.

 

If “jumper cables” are used for emergency starting,

 

follow this procedure:

 

Jumper Cables

 

• Connect each end of the RED cable to the

 

POSITIVE (+) terminal on each battery, taking

 

care not to short against chassis.

 

• Connect one end of the BLACK cable to the

8011-642

NEGATIVE (-) terminal of the fully charged battery.

Jumper cable connection

 

• Connect the other end of the BLACK cable to a

 

good CHASSIS GROUND on the mower with the

 

discharged battery, away from the fuel tank and

 

battery.

 

To remove cables, reverse order

Remove BLACK cable first from chassis and then from the fully charged battery.

Remove RED cable last from both batteries.

32

Image 32
Contents Grizzly SE Page Contents Page Introduction Good Service Manufacturing NumberSymbols and decals Manual Performing any General Operation SafetySafety Instructions Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Rollover Protection System Rops Spark ArrestorsControls Control LocationsMotion Control Levers Hour Meter TrackingParking Brake Blade SwitchIgnition Switch Ignition switch RUN position Cutting Height Pedals FusesChoke Control Seat Adjustment Lever Fuel Shut Off ValveRefueling Steering OperationTraining Roll Bar and Safety Belt Before StartingStarting the Engine Set the throttle Turn to Start position Push choke in after starting To remove cables, reverse order Weak BatteryJumper Cables Running Ensure that no one is near mower when engaging blade switch Operating on HillsStopping the Engine Mowing Tips Manual Transport Maintenance Maintenance For replacing BatteryFor cleaning Tire Pressures Safety SystemFuel Filter Parking brake adjustment Neutral Adjustments Deck Belt Removal Deck Belt InstallationDeck Belt Belt Installation Pump BeltBelts Replacing Pump BeltCutting Blades Adjusting the Mower Deck Leveling DeckAnti-scalp Rollers Deck Lift SpringCleaning Removal and InstallationUse protective glasses when cleaning and washing Caster WheelsGeneral LubricationLubrication Schedule Wheel and Deck Zerks CablesFront Wheel Mount Front Wheel BearingsHydraulic Drive Fluid ChangePurging Procedures Troubleshooting guide Problem CauseTroubleshooting guide Winter Storage ServiceStorage Wiring Diagram Transmission Technical Data6029FX, 6029FX BF 7234FX, 7243FX BF Engine Dimension 6029FX, 6029FX BF 7234FX, 7243FX BF FrameTorque Specifications Hex Head Cap ScrewsStandard Hardware Metric Standard HardwareWarranty Black Bear, Kodiak & Grizzly MowersUSA requirements CE requirementsService Journal Delivery ServiceAction Stamp, signAfter 10 hours Date, mtr reading Stamp, signDaily Service Hour Service Service Journal Service Journal At least once each year Action Date, mtr reading Stamp, sign Page 115 276826R1 09/21/09