Dixon 966985401, 966985402 manual Safe Handling of Gasoline

Page 13

SAFETY

WARNING!

The engine must not be started when the driver’s floor plate or any protective plate for the mower deck’s drive belt is removed.

Safe Handling of Gasoline

To avoid personal injury or property damage, use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive.

Extinguish all cigarettes, cigars, pipes, and other sources of ignition.

Use only approved gasoline container.

Never remove gas cap or add fuel with the engine running. Allow engine to cool at least two (2) minutes before refueling.

Never fuel the machine indoors.

Never store the machine or fuel container where there is an open flame, spark, or pilot light such as on a water heater or other appliance.

Before beginning to refuel, minimize the risk of static electricity by touching a metal surface.

Never fill containers inside a vehicle or on a truck or trailer bed with plastic liner. Always place containers on the ground away from the vehicle when filling.

Remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, refuel such equipment with a portable container, rather than from a gasoline dispenser nozzle.

Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock-open device.

If fuel is spilled on clothing, change clothing immediately.

Never overfill fuel tank. Replace gas cap and tighten securely.

Do not start the engine near spilled fuel.

Never use gasoline as a cleaning agent.

If leaks arise in fuel system, engine must not be started until problem has been resolved.

Check the fuel level before each use and leave space for the fuel to expand, as the heat from the engine and the sun may otherwise cause the fuel to expand and overflow.

8011-516

Never fill the fuel tank indoors

WARNING!

The engine and the exhaust system become very hot during operation.

There is risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes before refueling.

13

Image 13
Contents Operator Manual Page Contents Page Introduction Manufacturing Number Good ServiceSymbols and decals Remove key before Safety Instructions SafetyGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsSteering Control Levers Parking Brake Ignition SwitchThrottle Control Choke Control Blade SwitchFuses Cutting Height Adjuster Seat Adjustment LeverHour Meter Tracking Fuel Shut Off ValveFuel Tank Steering TrainingStarting the Engine Before StartingMove the throttle to the middle position Open the fuel valve Jumper cables Weak BatteryTo remove cables, reverse order Running Operating On Hills Mowing Tips Stopping the Engine Manual Transport Maintenance Schedule MaintenanceEvery 50 hours To clean battery and terminals BatteryAlways use protective glasses when handling the battery Tire Pressures Safety SystemBelts Deck Belt InstallationDeck Belt Cutting Blades Belt installationPump Belt Replacing Pump Belt Belt removalRemove blade bolt by turning counterclockwise Leveling Adjusting the Mower DeckAnti-Scalp Rollers Removal and installation of caster wheel CleaningUse protective glasses when cleaning and washing Caster WheelsGeneral LubricationFront Wheel Bearings Front Wheel MountEngine Lubrication Fluid Change Hydraulic PumpPurging Problem Cause TroubleshootingTroubleshooting Winter Storage ServiceSchematic Torque Specifications Technical DataStandard Hardware Engine 966985401Transmission Equipment Overall dimensionsProductivity CE requirements USA requirementsDixon ZTR Commercial / Residential WarrantyDelivery Service Service JournalAction Date, mtr reading, stamp, sign After the First 10 Hours Hour ServiceService Journal At Least Once Each Year Service Journal Service Journal Service Journal Page 115 354727R1 01/06/10