Seat Assembly Instructions, Do not Tighten Securely

SEAT ASSEMBLY INSTRUCTIONS

1.Place seat back against frame of seat bottom. Align top & bottom holes in frame with the t-nuts in seat back. Insert (4) 1/4-20 Phillips machine screws to attach frame to seat back. DO NOT TIGHTEN SECURELY.

2.Place (1) armrest bracket against seat back, aligning mounting holes in bracket and seat back.

3.Insert (2) 5/16-18 X 5/8" tapping screws through holes in bracket & frame and start screw threads.

DO NOT TIGHTEN SECURELY.

4.Insert (1) 1/4-20 X 3/4" Phillips machine screw through remaining hole in bracket and start screw threads. DO NOT TIGHTEN SECURELY.

5.Repeat steps 2 through 4 for the other armrest.

6.Tighten all screws.

7.Align back cover to seat back. Secure with (4) #14 X 5/8" wood screws and (4) 5/16" SAE washers in recesses provided.

8.Slide armrest onto mounting bracket pin.

9.Insert set screw in rear of armrest, securing armrest to mounting bracket.

10.Repeat steps 8 & 9 for other armrest.

11.Center utility box on seat back cover and fasten with drill & tap screws and washers provided in separate hardware package.

Page 7