Dixon 560 manual Upper Control Lever Installation

Page 12

UPPER CONTROL LEVER INSTALLATION

1.Raise rear body cover to fully open position.

2.Install flat washer on right hand swivel plate weldment. Next install right hand control lever, then second flat washer.

3.Push control lever into the neutral slot and install (2) cup washers, (1) flat washer and jam nut. (See illustration)

4.Tighten jam nut. Proper tightness or tension on jam nut is achieved when swing out movement of upper control levers requires some pressure. Levers should not fall to the side or be sloppy in movement.

5.Repeat above procedure on left side.

Page 9

Image 12
Contents Page See your dealer for warranty service, parts and repairs Index Safety Safety Reminders Read Carefully Before Operation Safety Reminders Dixon Limited Warranty Policy -- HYDRO-GEAR Models Specifications Engine Starting System Tires Capacities DimensionsSET UP and Service Seat Assembly Instructions Do not Tighten SecurelySeat Assembly Instructions Upper Control Lever Installation Mower Deck Installation Mower Deck Leveling Procedure Final Preparation Mower Deck DeflectorOperation Instructions Hydrostatic Drive SystemOperation Instructions Care and Maintenance Model Procedure for Electric Clutch Adjustment Reverse procedure to re-install deck assembly Drive System Adjustments Adjustment Points for T-BOX Belt Tension Forward Lever Stop Adjustment Locations Care and Maintenance Model Cleaning the MowerTroubleshooting Drive System Troubleshooting Page Page Page Page Page Page Page ZTR 560 Parts List ZTR 560 Parts List Clutch Spacer Spacer 1/2 ODX 1/4 ZTR 560 Parts List Page Page FAX 316 251