Dixon 8000D manual Mower Blade Switch, Ignition Switch, Throttle Control Lever, Circuit Breaker

CONTROLS

MOWER BLADE SWITCH:

To engage blades: pull up on switch

To disengage blades: push down

IGNITION SWITCH:

•Turn to run position to energize glow plugs.

•Turn to start position when glow plug light turns off, then crank engine. Release when it starts.

•For headlights - rotate switch one notch counter-clockwise from run.

Note: Remove key when mower is not in use.

THROTTLE CONTROL LEVER:

•Located on control panel to operator’s right.

•Controls engine speed.

•While mowing, throttle control should be set to MAXIMUM or wide open setting to insure adequate cooling of the engine and to maintain mower deck blade speed.

CIRCUIT BREAKER:

•If circuit breaker pops up, it disconnects the power. Wait 2 minutes then pull up and push to reset.

•If it pops up again, there is a short circuit. Stop and find fault or contact your dealer.

GLOW PLUG LIGHT:

•Light is energized when ignition switch is first put in run position. Glow light cycle time is five seconds.

WATER IN FUEL LIGHT:

•Light comes on when engine is running and fuel has water in it.

17