Dixon 13633-0702 manual Mower Deck Leveling Procedure

Page 37

CARE AND MAINTENANCE

MOWER DECK LEVELING PROCEDURE:

1.Place mower on a smooth, level surface and check tire pressures to insure correct stance. Tires should be inflated as follows.

Front: 16 - 21 lbs

Rear: 8 - 14 lbs

2.Turn each outer blade tip to align with the deck in a side to side manner.

3.Measure from the floor surface up to the bottom of the blade tip on the discharge side of the mower. Retain this measurement. Move to the opposite side and check to see if that measurement is the same. If adjustment is required, turn nut on one or both of the rear L-rods until both measurements are equal.

4.Turn each outer blade tip to align with the deck in a front to rear manner.

5.Measure from the floor surface up to the bottom of the blade tips at both the front and rear of the blades. Rear of blade tips should be to 1/8" to 3/8" higher that the front of blade tips. If adjustment is necessary, turn nut on front L-rod.

NOTE:

This will place the mower deck in a base measurement position.

 

Additional adjustment may be required to achieve desired cut for

 

the type of grass or conditions involved.

37

Image 37
Contents Series Important Read Carefully Index Safety Warranty Policy SpecificationsBlade Contact TIP Over RUN Over Back Over SafetySafety Alert Symbol Never carry passengers General OperationGeneral Operation Do not Slope OperationChildren Service Service Excluded Dixon Limited Warranty Policy Residential HydroModel ZTR 4515, 4516 SpecificationsSeat Adjustment Instructions Control Levers ControlsTo SET Parking Brake Parking BrakeTransmission Drive System Circuit Breaker Blade DriveThrottle Control Lever Mower Deck CUT Height Lift LeverBefore Operating Mower Operation InstructionsTo Free Wheel Machine Unlock Transmission Towing Trailers and Other AttachmentsParking Brake Switch Test Testing of Safety Interlock SystemsControl Lever Switch Test Seat Switch Test Blade Drive Switch TestEngine should Stop Starting Instructions 4515 Starting Instructions Side Discharge of the Clippings Grass Height and Cutting Suggestions Do not attempt to cut grass when it is wetMowing with a Mulching Attachment Mowing with a Mulching Attachment Mowing with a Grass Catcher Attachment Mowing with a Grass Catcher Attachment Maintenance Schedule Care and MaintenanceOFF Season Battery Storage BatteryEngine TiresCutter Blade Maintenance Belt Tension BeltsNeutral Adjustment Stop engine and remove rear of machine from jack or blocks Neutral AdjustmentForward Travel Speed Adjustment Mower Deck Leveling Procedure Deck Removal Changing the Engine OIL OIL Fill Lubrication Service IntervalsBrake System ChassisWarranty Cleaning the MowerPARTS/SERVICE Electrical SystemsDeck Standard Service Parts ListBriggs & Stratton AIR and OIL Filter Part Numbers Kohler AIR and OIL Filter Part NumbersEngine WON’T Turn Over TroubleshootingEngine Runs but Mower WON’T Move Forward Page Name Address Owner InformationZTRMowers