OPERATION
TIPS FOR IMPROVED BAGGING
OPERATION
Follow the mower operation instructions in your mower operator’s manual.
When operating your grass bagger on a lawn where grass and leaf bagging equipment has not been used, you are picking up thatch and debris that has accumulated for long periods of time. The amount collected and the total time of operation may be greater than you will experience with regular use of your grass bagger.
•Always run throttle at full speed when bag- ging.
•Select a speed low enough to give good mower cutting performance, good quality cut and good bagging performance.
NOTE: It may be necessary to overlap width of cut to suit your conditions.
•If grass is extremely tall, it should be mowed twice. The first time relatively high, the second time to desired height.
•Use left hand side of mower for trimming.
•Plastic trash bags (3.0 mil, 30 gallon) can be inserted inside grass bagger containers for ease of debris disposal. To remove the plastic trash bags when full:
a.Disengage blades, shift into neutral, engage the parking brake and stop the engine.
b.Unlatch and raise cover.
c.Remove one container at a time by grasping container handles and pulling toward the rear, off of the tube rails.
d.With the container resting on the ground, close and secure the top of the plastic lawn bag.
e.Tip the container on its side and slide the filled bag from the container.
f.Install a new plastic lawn bag with the edges of the bag draped over upper lip of the Container (for replacement bags refer to REPLACEMENT PARTS).
g.Repeat for other containers.
h.Reinstall containers making sure right container overlaps left container at center supports.
i.Close cover and secure latches over center support tubes.
•Avoid cutting wet grass or in the morning while the dew is still heavy. Grass clippings collected under these conditions tend to be sticky and adhere to the walls of the flow path causing clogging.
•If the grass bagger fails to pick up cut grass or leaves, it is an indication that clogging has occurred in the system or that the grass bagger containers are full.
a.Disengage blades, place motion control levers in neutral position, engage parking brake and stop engine.
-Unlatch and raise cover.
-Slide out containers and dispose of clippings.
-Replace containers, close cover, and latch.
b.Check for clogging.
-Remove all debris in chute.
-Reassemble chutes.
CAUTION
•DO NOT operate mower with grass bagger partially installed.
•Disengage blades and stop engine before leaving mower seat to empty containers, unclogging chutes, etc.
•Close cover before starting.
•Disengage mower blades when crossing driveways or gravel surfaces and other areas where thrown objects could be a hazard.
•DO NOT attempt to vacuum up cans or other potentially hazardous projectiles.
11