1BAGGER Support Assembly

ASSEMBLY

1.Remove the side bolts on the engine guard.

2.Using bagger support as a template, drill one 11/32 hole into the engine guard at the center bottom. (See illustration) Attach bagger support to engine guard using with four

3/8 -16 x ¾ bolts and four 3/8 -16 nyloc nuts. hardware removed in Step 1. Make sure support strap tabs are facing to the rear.

3.Attach hanger bracket to bagger support with four 5/16 -18 x 1 carriage bolts and four 5/16 nyloc nuts. See illustration.

4.Attach support straps to bagger support at the support strap tabs, using two 5/16-18 x 1 hex head bolts and two 5/16 nyloc nuts.

5.Align engine guard with attached support and hanger bracket to rear of mower. Secure the opposite end of the support strap and the engine guard to the sides ofthe mower with two 5/16 -18 x 1 carriage bolts and two 5/16 nyloc nuts.

Hanger Bracket

Support Strap Tab

Bagger Support

Engine Guard

2MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY

NOTE: For ease of assembly, you may wish assistance from another person for mounting the cover assembly to mower.

1.Position cover assembly on ground behind mower.

2.Lift and rotate cover to align the cover bracket with hanger bracket and slide the cover down until secure.

Frame Bracket

Hanger

Bracket

Drill One 11/32 hole into engine guard to match this hole

Support Strap