Assembly

Assembly Instructions

Tools Required:
Ratchet	(2) 3/4" Wrench
Torque Wrench	3/4" Socket
1/2" Wrench	Flat Screw Driver
1/2" Socket	(2) 1” Wrench - open end
9/16" Wrench
9/16" Socket

RAM/RAM MAG

1.Remove clamshell from crate.

2.Remove two 5/16 x 3/4 carriage bolts from the lower flange of the rear guard on the mower.

3.Place (539 114781) Mount Bracket, Lower in place and secure using four (539 111785) 3/8 x 3/4 carriage bolts, four (539 976979) 3/ 8 nyloc hex nut and two (539 107271) 5/16 x 1 carriage bolts. Reuse the two 5/16 nyloc hex nuts previously removed from the 5/16 x 3/4 carriage bolts. See Figure 1.

4.Lift seat and latch with seat latch.

5.Remove seat springs.

6.Place (539 114786) Plate, Support, Linkage on frame.

7.Reposition springs and secure with (990209) 5/16 x 1 hex bolts and hex nut previously removed from seat springs. See Figure 2.

8.Attach two (539 114783) Linkage, Support to the clamshell assembly as shown in Fig- ure 2.

9.Secure with two (539 100476) 5/8 hex jam nut and two (539 115591) 5/8 nyloc hex nut as shown. Do not tighten nuts.

REAR GUARD

LOWER FLANGE

539 114781 MOUNT BRACKET, LOWER

FIGURE 1

539 114786 PLATE,

SUPPORT, LINKAGE

FIGURE 2