Dixon 14295-0804 manual Mower Deck Leveling Procedure, Care And Maintenance

Page 40

CARE AND MAINTENANCE

MOWER DECK LEVELING PROCEDURE:

1.Place mower on a smooth, level surface and check tire pressures to insure correct stance. Tires should be inflated as follows.

Front: 16 - 21 lbs

Rear: 8 - 14 lbs

2.Turn blade so tips align with the deck in a side to side manner.

3.Measure from the floor surface up to the bottom of the blade tip on the discharge side of the mower. Retain this measurement. Move to the opposite side and check to see if that measurement is the same. If adjustment is required, turn nut on one or both of the rear L-rods until both measurements are equal.

4.Turn blade so tips align with the deck in a front to rear manner.

5.Measure from the floor surface up to the bottom of the blade tip at both the front and rear of the blade. Rear blade tip should be 1/8" to 1/4" higher than the front blade tip. If adjustment is necessary, turn nut on front L-rod.

(See Illustration A, page 41)

NOTE: This will place the mower deck in a base measurement position. Additional adjustment may be required to achieve desired cut for the type of grass or conditions involved.

40

Image 40

Contents Safety Instructions & Operator’s Manual ZEETERIMPORTANT - READ CAREFULLY TABLE OF CONTENTS SAFETY & WARNINGCARE & MAINTENANCE TROUBLESHOOTINGSAFETY Blade Contact Tip Over Run Over Back OverSafety Alert Symbol When you see this symbol, BE ALERT to the potential for injuryFollow the recommended safety precautions and safe operating practicesGENERAL OPERATION GENERAL OPERATION continued Maintain or replace safety & instruction labels as needed SLOPE OPERATION SLOPE OPERATION continued Do not mow on wet grass. Reduced traction could cause sliding FIRE HAZARDS FIRE HAZARDS continued CHILDREN SERVICE ZEETER - Residential Mower DIXON ZTR RESIDENTIAL WARRANTY POLICYSPECIFICATIONS SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICECONTROLS CONTROL LEVERSPARKING BRAKE TO SET PARKING BRAKE1. Read engine manufacturer’s operating and maintenance instructions 7. Know how to stop engine. Turn key to off positionBEFORE OPERATING MOWER 3. Check engine oil 4. Check fuel cap to be sure it is in placeTRANSMISSION DRIVE SYSTEM TOWING TRAILERS AND OTHER ATTACHMENTSTHROTTLE CONTROL LEVER BLADE DRIVEMOWER DECK CUT HEIGHT LIFT LEVER OPERATION INSTRUCTIONS STARTING INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMS MOWING WITH A MULCHING ATTACHMENT MOWING WITH A MULCHING ATTACHMENT continued MOWING WITH A GRASS CATCHER ATTACHMENT Failure to observe the following instructions MOWING WITH A GRASS CATCHER ATTACHMENT continuedWARNING may result in personal injury SIDE DISCHARGE OF THE CLIPPINGS 5. Maintain sharp blades throughout the cutting seasonGRASS HEIGHT & CUTTING SUGGESTIONS CARE AND MAINTENANCE MAINTENANCE SCHEDULEBefore performing any maintenance, turn off engine allow to cool & remove key Use extreme care when working on machineryCUTTER BLADE MAINTENANCE BATTERY ENGINELUBRICATION TIRES BELTSBELT TENSION Engine to Transmission Belt - P/NCLEANING THE MOWER WARRANTYPARTS/SERVICE ELECTRICAL SYSTEMSCHANGING THE ENGINE OIL OIL FILL MOWER DECK LEVELING PROCEDURE Illustration A IllustrationB Maintenance REAR CHAIN ADJUSTMENTDO NOT OVERTIGHTEN CHAIN DECK REMOVAL DRIVE SYSTEM ADJUSTMENTS BLADES STANDARD SERVICE PARTS LISTENGINE AIR AND OIL FILTERS TROUBLESHOOTING 1. ENGINE WON’T TURN OVER2. ENGINE WILL TURN OVER BUT WON’T START 3. HARD TO START ENGINE7. MOWER LOSES POWER OR TRANSMISSION OVERHEATS 8. ENGINE STALLS WHEN BLADES ARE ENGAGED6. ENGINE RUNS BUT MOWER WON’T MOVE FORWARD 9. DRIVE SYSTEMPage Page Page OWNER’S INFORMATION Name AddressDATE OIL CHANGED DATE ENGINE TUNEDZEETER Dixon and ZTR are registered trademarks of Dixon Industries, Inccancer, birth defects or other reproductive harm