Dixon 14295-0804 manual Specifications Subject To Change Without Notice

Page 17

	SPECIFICATIONS
CHASSIS:	11 GA welded channel frame
BODY:	All body parts made of rotational molded polyethylene.
	Front body contains access panel for battery service.
	Seat tilts forward to allow transmission service.
MOWER DECK:	11 GA stamped steel construction. Single 30” cut blade.
	Cut height approximately 1-1/2”- 4” via 7-position lift
	handle.
BLADE DRIVE:	Mechanical; hand lever engagement
TRANSMISSION:	Each rear wheel is independently driven by chain and
	sprockets through a friction mechanical drive.
ENGINE:	11HP Briggs & Stratton I/C, 4-cycle, single cylinder, air-
	cooled, gasoline, vertical shaft, aluminum head and block.

STARTING SYSTEM: Electric by key switch operation with safety interlocks on

	parking brake and blade drive.
TIRES:	Front	9 x 3.50-4 Smooth Tread
	Rear	16 x 6.50-8 Turf Saver
RECOMMENDED	Front	16-21 PSI
TIRE PRESSURE:	Rear	8-14 PSI
CAPACITIES:	Fuel	3 quart
	Engine	1.25 quarts oil
DIMENSIONS:	Width	32” outside rear wheel measurement
	Width	40” overall width of deck with deflector
	Height	31” to top edge of seat
	Length	65.5” hitch tab to front
	Weight	390 lbs.

Additional information may be provided elsewhere in this manual.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

17

Image 17

Contents ZEETER Safety Instructions & Operator’s ManualIMPORTANT - READ CAREFULLY SAFETY & WARNING TABLE OF CONTENTSCARE & MAINTENANCE TROUBLESHOOTINGBlade Contact Tip Over Run Over Back Over SAFETYWhen you see this symbol, BE ALERT to the potential for injury Safety Alert SymbolFollow the recommended safety precautions and safe operating practicesGENERAL OPERATION GENERAL OPERATION continued Maintain or replace safety & instruction labels as needed SLOPE OPERATION SLOPE OPERATION continued Do not mow on wet grass. Reduced traction could cause sliding FIRE HAZARDS FIRE HAZARDS continued CHILDREN SERVICE DIXON ZTR RESIDENTIAL WARRANTY POLICY ZEETER - Residential MowerSPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE SPECIFICATIONSCONTROL LEVERS CONTROLSTO SET PARKING BRAKE PARKING BRAKE7. Know how to stop engine. Turn key to off position 1. Read engine manufacturer’s operating and maintenance instructionsBEFORE OPERATING MOWER 3. Check engine oil 4. Check fuel cap to be sure it is in placeTOWING TRAILERS AND OTHER ATTACHMENTS TRANSMISSION DRIVE SYSTEMMOWER DECK CUT HEIGHT LIFT LEVER BLADE DRIVETHROTTLE CONTROL LEVER OPERATION INSTRUCTIONS STARTING INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMS MOWING WITH A MULCHING ATTACHMENT MOWING WITH A MULCHING ATTACHMENT continued MOWING WITH A GRASS CATCHER ATTACHMENT WARNING may result in personal injury MOWING WITH A GRASS CATCHER ATTACHMENT continuedFailure to observe the following instructions 5. Maintain sharp blades throughout the cutting season SIDE DISCHARGE OF THE CLIPPINGSGRASS HEIGHT & CUTTING SUGGESTIONS MAINTENANCE SCHEDULE CARE AND MAINTENANCEBefore performing any maintenance, turn off engine allow to cool & remove key Use extreme care when working on machineryCUTTER BLADE MAINTENANCE ENGINE BATTERYLUBRICATION BELTS TIRESBELT TENSION Engine to Transmission Belt - P/NWARRANTY CLEANING THE MOWERPARTS/SERVICE ELECTRICAL SYSTEMSCHANGING THE ENGINE OIL OIL FILL MOWER DECK LEVELING PROCEDURE Illustration A IllustrationB DO NOT OVERTIGHTEN CHAIN REAR CHAIN ADJUSTMENTMaintenance DECK REMOVAL DRIVE SYSTEM ADJUSTMENTS ENGINE AIR AND OIL FILTERS STANDARD SERVICE PARTS LISTBLADES 1. ENGINE WON’T TURN OVER TROUBLESHOOTING2. ENGINE WILL TURN OVER BUT WON’T START 3. HARD TO START ENGINE8. ENGINE STALLS WHEN BLADES ARE ENGAGED 7. MOWER LOSES POWER OR TRANSMISSION OVERHEATS6. ENGINE RUNS BUT MOWER WON’T MOVE FORWARD 9. DRIVE SYSTEMPage Page Page Name Address OWNER’S INFORMATIONDATE OIL CHANGED DATE ENGINE TUNEDcancer, birth defects or other reproductive harm Dixon and ZTR are registered trademarks of Dixon Industries, IncZEETER