Marantz CDR300 manual Controls, Connections rear

Controls, Connections (rear)

	1 2 3			4 5 6	7	8
MIX	LINE	AUX	DIGITAL	REMOTE
				RC-5 EXT. INT.
OUT	OUT	IN
R		R	IN	IN
				FOOT		DC IN
L		L	OUT	PEDAL		POWER
				OUT		ON OFF

MIX	1 MIX OUT jacks
OUT	Plug Right and Left RCA audio
R	cables in here to connect to the
	input of an amplifier or other
	external unit. Use for recording
L	onto an external recorder.
	Input from MIC/LINE (or INT MIC)
	and/or AUX jacks are output as

DIGITAL

IN

OUT

REMOTE

RC-5

IN

OUT

4DIGITAL IN and OUT jacks Plug RCA coaxial cables in here to connect to the input and/or output of an external digital unit.

Use IN for recording onto the CDR drive from an external digital audio source.

Use OUT for going to an external digital device.

5REMOTE RC-5 IN and OUT jacks

Plug RCA audio cables in here to connect to the input and output of an RC-5 remote control system.

The RC-5 control code list is on page 34.

line level output to an external recorder or amplifier. The signal is output before going to the CDR drive, so it is available for monitoring or recording even if the CDR drive is stopped. This signal cannot be equalized by the CDR300 tone controls.

Notes:

• For more information on the RC-5 system and

details regarding its operation please contact

Superscope Technologies at (630) 820-4800 or

www.superscope-marantzpro.com.

MIX LINE

OUT

R

AUX 2 LINE OUT jacks

Plug Right and Left RCA audio cables in here to connect to the input of an

• When an RC-5 remote control system is not used

the REMOTE EXT. INT. switch should be at INT.

REMOTE 6 REMOTE EXT. INT. switch

L

amplifier or other external unit. This signal can be equalized by the CDR300 tone controls.

EXT. INT.

Notes:

Switch to EXT. (external) when an external RC-5 remote control system is used.

AUX

IN

R

L

3AUX IN jacks

Plug Right and Left RCA audio cables in here to connect to the output of an external unit.

Use for recording onto the CDR drive from an external audio source such as a cassette deck, or CD player.

•Switch to INT. (internal) to enable the supplied IR (infrared) remote.

7FOOT PEDAL jack

An optional foot pedal can provide Play/Pause control for the CDR drive.

FOOT This jack does not perform pause or

PEDAL continue during recording. Foot pedal (FT200) is available from Superscope Technologies at (630) 820-4800 or www.superscope-marantzpro.com.

8Power plug

Plug one end of the supplied power cord in here and the other into an AC outlet.

- 15 -