Marantz CDR300 manual Controls, Connections rear contin- ued, DC in pin out, Power switch

Controls, Connections (rear) contin- ued

9 10

MIX	LINE	AUX	DIGITAL	REMOTE
				RC-5 EXT. INT.
OUT	OUT	IN
R		R	IN	IN
					FOOT	DC IN
L		L	OUT	OUT	PEDAL	POWER
						ON OFF

Push and release the SELECT control.

Turn the SELECT control to choose between Lead Acid and NiCd/NiMH.

L

dB-50 -30 -22	-16	-12	-8	-4	0
TOTAL TRACK R
CD
L
dB-50 -30 -22	-16	-12	-8	-4	0

TOTAL TRACK R

CD

DC IN 9 DC IN

The CDR300 can be powered

by a Lead Acid, NiCd, or NiMH battery power supply. A Lead Acid power supply is available

from Superscope Technologies (630) 820-4800 or www.superscope-marantzpro.com.

DC IN pin out

1

DC IN

112VDC -

22 not used

When correct push and release MENU/STORE.

How to use a DC power supply

Always begin recording sessions with a fully charged battery regardless of battery type.

Plug the DC power supply into DC IN (9). Push the Power switch (10) in to ON. Turn power on with the Standby POWER slide switch on the top of the unit.

Battery life depends on use and battery type. A low battery indicator is built in. When the CDR300 detects a low battery condition during recording the red STANDBY light flashes and the display alternates

3

4

3 not used

4 12VDC +

between PRESS STOP and LOW BATTERY.

L	L
dB-50 -30 -22 -16 -12 -8 -4 0	dB-50 -30 -22 -16 -12 -8 -4 0
TOTAL TRACK R	TOTAL TRACK R
CD-RW	CD-RW

POWER	10 Power switch
ON OFF

Push and release to turn power ON (in position). Push and release to turn power OFF (out position).

Normally, to retain memory, leave this switch at ON and turn power on and off with the Standby POWER slide switch on the top of the unit.

BATTERY SELECT

A DC power supply with Lead Acid, NiCd, or NiMH batteries can be used, but batteries differ in electrical characteristics.

Determine which battery type is used. With the CDR300 at Stop push and release the MENU/STORE button. Turn the SELECT control so BATTERY SE- LECT is displayed.

L

dB-50 -30 -22 -16 -12 -8 -4 0

TOTAL TRACK R

CD

Stop recording as soon as possible. When you stop recording the temporary TOC will automatically be updated so your recording is not lost.

After two minutes of LOW BATTERY the CDR300 will stop recording and will automatically update the temporary TOC.

Battery Backup

When both AC and DC power supplies are connected the DC supply serves as a battery backup when AC power is interrupted.

- 16 -