Conair Bath Spa Cleaning and Disinfecting Your Bath SPA, Recommended Massaging Times

CLEANING AND DISINFECTING YOUR BATH SPA

1)Your Bath Spa can be cleaned with any mild detergent or soap. Cleaning is recommended after each use.

2)Disinfect your unit periodically to keep it bacteria_free. With frequent use, disinfect weekly. With infrequent use, disinfect after each use.

RECOMMENDED MASSAGING TIMES

Spa massage should generally last only 15-20 minutes.

Caution: Read safety rules and operating instructions carefully. This product is intended for indoor use on permanent, right wall tubs. Do not use outdoors or on the walls of inflatable tubs or pools.

HOW TO ATTACH YOUR BATH SPA

TO YOUR TUB

1)Make sure unit is disconnected from the charger and the power knob is in the “OFF” position. The tub should be clean and empty of water.

2)Extend the folding arm and place unit along edge of tub so the unit is inside the tub and

the arm is resting on edge (Fig. 3).

3)Moisten suction cups to increase grip.

4)Secure suction cups by gently applying even pressure on bath spa against tub wall (Fig. 4).

5)Adjust suction cup on arm so that it adheres directly onto bathtub edge. See Suction Cup Position Adjustment section.

6)Adjust height of motor assembly to desired depth by moving motor housing up or down by hand. Built-in detents will hold the position you desire (Fig. 5).

7)Water may spray if unit is not level when turned on.

SUCTION CUP POSITION ADJUSTMENT

Suction cup underneath the handle can be in 1 of 4 positions to suit different bathtubs. (See Fig. 6) Loosen, remove and then replace screw after adjustment.

Position A: The outer most position for thick-sided tubs.

Position B: The inner most position for thin-sided tubs.

Position A

Position B

(Fig. 6)

FITTING AND REMOVING FILTER CAPS		ONE YEAR LIMITED WARRANTY			®
TO REMOVE CAPS		Conair will repair or replace, at our option, your appliance free of charge for 12 months
		from the date of purchase if the appliance is defective in workmanship or materials.
1) Turn cap about 20˚ counterclockwise (Fig. 7).
		To obtain service under this warranty, return the defective product to the service center nearest you,
(Filter caps are located on either side of the motor assembly.)
		together with your sales slip and $7.50 for postage and handling.
2) Line up single hash mark on cap with				B O D Y	B E N E F I T S TM/MD
		ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED
the center seam on the back body of the unit.
		TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
3) Pull cap away from unit.
		PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12 MONTH DURATION OF THIS
4) Rinse cap under water to remove hair, lint, etc.		WARRANTY.
TO REPLACE CAP		IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUEN-
		TIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED,
1) Push cap into body so that single hash mark
		WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental, or
on cap lines up with the center seam		consequential damages, so the above limitation may not apply to you. This warranty gives you
on the back body of the unit.		specific legal rights, and you may also have other rights which vary from province to province.
2) Turn cap clockwise about 20˚ until the double
hash marks on the cap line up with the center	(Fig. 7)	Service Centre:
seam on the back body of the unit.
		Conair Consumer Products Inc.
WARNING: Protect from excess lint, hair, etc... from easily getting caught
		156 Parkshore Drive
in motor, unit should never be used with the filter mesh removed. Injury		Brampton, Ontario
or damage to unit could result.		L6T 5M1
		Visit us on the web at: www.conair.com	IB-3996
		©2001 Conair Consumer Products Inc.	BTS4C
		Brampton, Ontario L6T 5M1	01CN1415

Dual Jet

BATH SPA

C O R D L E S S

For your safety and continued enjoyment of this product, always read the instruction book carefully before using.

(Fig. 3) (Fig. 4) (Fig. 5)

INSTRUCTION BOOKLET FOR BTS4C MODELS