OPERATING INSTRUCTIONS
Control Panel
On the control panel you can set the controller for single action mode where preset programs are run either statically, automatically or by
[MENU] Returns to Main menu or step backward through functions
[SET UP] Enters menu selection
[UP] Steps backward through menu selection
[DOWN] Steps forward through menu selection
MENU SETUP UP DOWN
Menu Diagram
System Setup
You will need to let the controller be aware of the number of par cans and/or panels connected in series. This is essential in order for the chase and flow programs to perform correctly through out the entire stretch of fixtures.
|
|
|
|
|
|
| Main Menu | ||||
|
|
|
|
|
|
|
|
|
|
|
|
M System |
| Setup |
|
|
| M Single |
| Action | |||
|
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
1 | DMX Ch |
|
| (0 – 508) |
| For a detailed | listing of Single | ||||
2 | Set Address | (N / A) |
| ||||||||
| Action programs proceed to the | ||||||||||
3 | Lamp Amount | (0 – 250) |
| next page. | |||||||
|
|
|
|
| |||||||
Init ial Setu p
1.Press the MODE button until the display shows “M System Setup”.
2.Press the SETUP button then the UP button once. It will show “3 Lamp Amount”.
3.Press the SETUP button to enter the function. A number will now appear to the right of the text as shown here in an example. “3 Lamp Amount 34”.
4.Use the UP and DOWN buttons to locate a number between 0 and 250. This represents the number of fixtures connected.
5.Press the MODE button to set this function.
Re - in iti al ization
Whenever a fixture is removed, replaced or exchanged please follow the following instructions.
1.Press the MODE button until the display shows “M System Setup”.
2.Press the SETUP button then the UP button twice. It will show “2 Set Address”.
3.Press the SETUP button to
4.Proceed to prior instruction “Initial Setup” and
COLORmist™ System User Manual | 7 |