Chauvet MIST-PS8 DMX Control Mode, System Configuration & Connection, Setti ng t he DM X ad dress

Page 9

Operating Instructions

DMX Control Mode

With exception to the system setup process all control functions on the controller can be accessed and executed externally via a Universal DMX controller. First you must connect the LED-CHVA controller to an existing DMX daisy chain. The controller is addressable just like any other DMX device or fixture and it will be controlled as if it were a fixture in most intelligent light consoles.

Setti ng t he DM X ad dress

1.Press the MODE button until the display shows M System Setup.

2.Press the SETUP button to enter the M System Setupmenu function.

3.The controller should display immediately 1 Dmx Ch. Press the SETUP button to select function.

4.Use the UP and DOWN buttons to increase or decrease the channel values. This value represents the starting address for this device. The controller occupies 4 channels of DMX

5.The unit will now respond to DMX command. Do not press any other buttons other than to change the channel values.

The next step may require you to create a device profile within your lighting controller. Proceed to section DMX Channel Valuesfor a detailed chart of the control values for each channel of DMX.

Runn ing in DM X M ode

If the control panel menu displays 1 Dmx Chpress SETUP to activate DMX control mode. For instructions on arriving at this menu item repeat the instructions Setting the DMX addresslocated directly above this subject.

Daisy Ch ai n Conn ecti on

1.Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture.

2.Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.

System Configuration & Connection

 

 

 

 

 

 

 

 

 

 

DMX Daisy Chain

Please read the Appendix Section MIST-PS8 Power Unit

From Controller

Configurations, for a detailed description and illustration of

 

 

 

the maximum length and load capacity of the power unit.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DMX line

Power-Signal Cable

COLORmistPanel

COLORmist

 

 

 

 

 

 

 

 

 

 

 

 

DMX line

COLORmistController

COLORmistPower Unit

COLORmistSystem User Manual

9

2005-10-10/18:36

Image 9
Contents COLORmist System Table of Content Safety Instructions AC PowerBefore YOU Begin COLORmist SystemFeatures IntroductionMIST-CON DMX Channel Summary Product Overview Menu Setup DownPower SetupMounting MIST-PAR80 Mounting MIST-PANOperating Instructions Menu Diagram System SetupControl Panel Init ial Setu pO o s i n g S i n g l e Ac t i o n P r o g r a m s Single Action ProgramsSystem Configuration & Connection DMX Control ModeSetti ng t he DM X ad dress Runn ing in DM X M odeAppendix DMX PrimerFixtu re Li nking Programs DMX Channel ValuesMIST-PS8 Power Unit Configurations Returns ProcedureClaims Technical Support Technical Specifications