Power Linking DMX Linking | Chauvet E-190WW instruction

Setup

Power Linking

DMX Linking

DMX Modes

Master/Slave

Connectivity

The OVATION™ E-190WW supports power linking. You can power link up to 4 units on 120 V; up to 7 units on 208 V; or up to 8 units on 230 V.

This product comes with a Neutrik® powerCON® input power cord. This product does not come with a power linking cable; however, a power linking cable is available as an option.

You can link the OVATION™ E-190WW to a DMX controller using a standard DMX serial connection. If using other DMX-compatible products with the OVATION™ E- 190WW, you can control each individually with a single DMX controller.

The OVATION™ E-190WW uses the standard DMX data connection for the 1-, 2- and 3-channel DMX modes.

∙Refer to the Introduction chapter for a brief description of these modes.

∙Refer to the Operation chapter to learn how to configure the OVATION™ E-190WW to work in these modes.

∙The DMX Values section provides you with detailed information regarding the DMX modes.

The Master/Slave mode allows a single OVATION™ E-190WW (the “master”) to control the actions of one or more OVATION™ E-190WW units (the “slaves”) without the need of a DMX controller to control the slaves. Once set and connected, the slaves will operate in unison with the master. For instructions on connecting and configuring this product, see Master/Slave Mode.

DO NOT connect a DMX controller to products operating in Slave mode. The DMX controller signals may interfere with the signals from the master product.

The Operation section of this manual provides detailed instructions on how to configure the master and slaves.

If you are not familiar with or need more information about DMX standards, master/slave connectivity, or the DMX cables needed to link this product to a DMX controller, download the DMX Primer from the CHAUVET® website:

www.chauvetpro.com.

OVATION™ E-190WW User Manual Rev. 3

-7-