Operation
Master/Slave Mode
Drop-In Iris Slot
The Master/Slave mode allows a single OVATION™
Configure the units as indicated below.
The Slaves:
1.Go to the RUN main level.
2.Select SLAV.
3.Connect the DMX input of the first slave to the DMX output of the master.
4.Connect the DMX input of the subsequent slaves to the DMX output of the previous slave.
5.Finish setting and connecting all the slaves.
The Master:
1.Go to the SET main level.
2.Select the MCON programming level.
3.Select MAST.
Note: If you select SELF, no DMX signals are sent to the slaves.
4.Make the master the first product in the DMX daisy chain.
5.Control the master using the DMX controller and the slaves will operate in unison.
Do not connect a DMX controller to the products configured for slave operation. The DMX controller may interfere with signals from the master.
The OVATION™
1.Using a
2.Slide to cover forward.
3.Insert the iris or motorized pattern device.
Note: Make sure the iris handle extends upward from the slot.
4.Slide the cover back. Make sure the iris handle moves freely.
5.Tighten the screws to secure the cover.
Cover Screws
Iris Handle
Drop-in Iris
Slot Cover
Sample
∙When not using the iris slot, replace and secure the slot cover to prevent light leakage during operation.
∙When obtaining any optional iris accessories, be sure the items are compatible with the OVATION™
OVATION™ |