Chauvet E-190WW DMX Values, DMX Personality DMX Control Loss of Signal Setting, Dmx, Std.P

Operation

DMX Values

UNO

DOS

STD.P

Channel	Function	Value	Percent/Setting
1	Dimmer	000 ó 255	0–100%
Channel	Function	Value	Percent/Setting
1	Dimmer	000 ó 255	0–100%
2	Dimmer Fine	000 ó 255	0–100%
Channel	Function	Value	Percent/Setting
1	Dimmer	000 ó 255	0–100%
2	Dimmer Fine	000 ó 255	0–100%
		000 ó 009	No function
		010 ó 099	Strobe (slow to fast)
3	Strobe	100 ó 109	No function
		110 ó 179	Lighting effect
		180 ó 189	No function
		190 ó 255	Random strobe

DMX Personality

DMX Control

Loss of Signal Setting

Set the DMX personality as follows.

1.Go to the SET main level.

2.Select the PERS programming level.

3.Select the desired personality: UNO (1-channel), DOS (2-channel), or STD.P (3-channel).

∙See the DMX Control section for the highest starting address you can select for each personality.

∙Make sure that the starting addresses on the various products do not overlap due to the new personality setting.

DMX Control allows you to assign each product to a unique starting address on the DMX controller. All products with the same starting address will respond in unison.

1.Select a DMX personality.

2.Set the running mode:

∙Go to the RUN main level.

∙Select DMX.

Note: For information on the SLAV option, see Master/Slave Mode.

3.Set the starting address:

∙Go to the ADDR main level.

∙Select the starting address D.001–D.512.

The highest recommended starting address for each DMX mode is as follows:

DMX	DMX	DMX	DMX	DMX	DMX
Mode	Address	Mode	Address	Mode	Address
UNO	512	DOS	511	STD.P	510

This setting controls how the product responds when the DMX signal is lost.

1.Go to the SET main level.

2.Select the DERR programming level.

∙Select BLAK to turn off the LEDs when the signal is lost.

∙Select SAVE to use the last command programmed when the signal is lost.

OVATION™ E-190WW User Manual Rev. 3 -11-