DMX Channel Values, Setting the Starting Address

Custom Static Color Mixing

This fixture has the ability to accept custom static color settings. These are accessed via the control panel. Please see the instructions below for further explanation.

1.Press <MENU> until U--appears on the LED screen.

2.Press <ENTER>.

3.Using <UP> and <DOWN>, select the desired color value (000~100). By selecting 000, the color will remain off.

4.Press <ENTER> to continue to the next color (r, C).

5.Using <UP> and <DOWN>, select the desired color value (000~100). By selecting 000, the color will remain off.

6.Continue until the desired mix is obtained.

7.Press <ENTER> to save the final color setting. This will move the selection to the following color. However, this is necessary to save the modification.

The colors are represented by the following in the menu map: r---= Warm White (000~100)

C---= Cool White (000~100)

DMX Channel Values

4-CH

CHANNEL

VALUE

FUNCTION

1Master Dimmer

000 ó 255 Dimmer: 0%~100%

2Warm White (2900K)

000 ó 255 Dimmer: 0%~100%

3Cool White (6300K) 000 ó 255 Dimmer: 0%~100%

4		Strobe
4	000 ó 015	No function
	016 ó 255	Strobe: 0%~100%

2-CH

CHANNEL

VALUE

FUNCTION

1Warm White (2900K)

000 ó 255 Dimmer: 0%~100%

2Cool White (6300K) 000 ó 255 Dimmer: 0%~100%

Setting the Starting Address

This DMX mode enables the use of a universal DMX controller device. Each fixture requires a start address from 1~512. A fixture requiring one or more channels for control begins to read the data on the channel indicated by the start address. For example, a fixture that uses six DMX channels and was addressed to start on DMX channel 100, would read data from channels: 100, 101, 102, 103, 104, and 105. Choose start addresses so that the channels used do not overlap, and note the start address selected for future reference.

LED Par 64-36VW B&C User Manual

Rev. 4