Veneto ™
Canopy Hardware
Canopy Screw (4) | Screw Driver |
Securing the Canopy
Canopy Screws
Step 9. Carefully tuck the wires around the Receiver and Hanging Bracket as not to loosen the wire caps.
Step 10. Insert 2 Canopy Screws into the Hanging Plate diagonally across from each other so they match the keyholes on the canopy.
WARNING: Do not let wires become lodged between Hanger Bracket and Canopy.
Keyhole Slots
Round
Step 11. Raise the Canopy over the Hanger Bracket. Hole Align the partially installed screws with the key slots
in the canopy.
Step 12. Twist the Canopy clockwise to secure.
Step 13. Install the third & fourth canopy screws in the round holes on Canopy. Securely tighten all four screws.
Step 14. Using both hands, push the CanopyTrim ring up to the top of the Canopy.
Step 15. Twist the CanopyTrim ring clockwise to secure it to the Canopy.
Keyhole Slot
13