SWITCH HOUSING BRACKET/ CAP INSTALLATION
SWITCH HOUSING BRACKET/CAP HARDWARE (not to scale)
|
| Switch Housing | |
| Switch Housing Bracket | Mount Screw | |
| (Removed in Step 10) | ||
Switch Housing Cap | (2) | ||
|
| (2) |
Step 6a. Take the two switch housing bracket you removed in step 4g and snap it into the holes in the switch housing. This is to prevent any wires getting pushed down near the motor. Make sure no wires are in the way or pinched in these
NOTE: If you have purchased an accessory light fixture for this fan, please refer to the instructions included with the light fixture. If not, continue with Step 6b.
Step 6b. Line up the two clearance holes in the cap with the two threaded holes on the raised rim of the switch housing. Press the cap onto the switch housing to seat the guide pins into the alignment holes of the switch housing.
Step 6c. Using the two
8