VERSATOUCH2 Operation | Casablanca Fan Company 86UxxM specification

Versa•Touch2®

VERSA•TOUCH2 OPERATION

Fan Control		SEND SIGNAL
		LED
To start the fan. Press the selected speed button to run the fan at the desired speed.


1=Low speed 2=Medium speed	3=High speed	UP
To turn off the fan. Press the FAN OFF	button.	Light
Airflow Direction
To reverse the airflow press the REVERSE button. Reverse operates at any speed whether fanMED
is on or off. The fan returns to its set speed after reversing.		LO
Light Control

Turn the light on or off independently from the fan by pressing the UPLIGHT DOWNLIGHT OR
BOTH button. (This is a rocker switch. Press the left side for the Uplight, right side for the
Downlight , and the middle for both.)	Keep pressing the button in excess of 0.7 seconds, it
becomes a dimmer. The light varies from ‘bright’ to ‘dim’ over approximately 8 seconds. This

sequence will reverse the light when it reaches the brightest or dimmest level if you continue

	to hold the LIGHT button. Release the button when the desired level is reached.	REVERSE
	Auto Resume	REVERSE
	Auto Resume

Quick (pressing less than 0.7 seconds) on/off operation of the LIGHT button maintains the desired brightness level set previously.

VERSA•TOUCH CHANGING FREQUENCY SETTING

LIGHT

DOWN

Light

FAN

OFF

Note: All fans leave the factory set to ‘00000’.

You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.

Step 1. At the circuit breaker or fuse box, turn the power off for the fan you want to change.

Step 2. Open the battery door of the Versa•Touch control and remove the batteries.

Step 3. Change the dip switch settings, assuring that they are different from the previously installed Versa•Touch fan.

Step 4. Re-install the batteries and the battery door on the control.

Step 5. At the circuit breaker or fuse box, turn the power back on for the fan whose frequency you are changing.

Step 6. Within 20 seconds of restoring power, push the Hi, Med, and Lo buttons (in that order).

dip switch

set to ‘10000’

versa•touch 2

control

(back)

dip switch

set to ‘01001’

Note: You may want to label your controls to assure you do not mix them up.

WARNING: Do not turn the power off at the circuit breaker, then back on, for the previously installed Versa•Touch 2 fan(s), as you may inadvertantly change the frequency set- tings for it as well.

WITHIN 20 SECONDS OF TURNING THE FAN ON, PRESS IN THIS ORDER TO SET NEW FREQUENCY:

MED

LO LO

MED

HIGH

VERSA•TOUCH2 IF FAN DOES NOT WORK

If the fan is not functioning after installation:

Step 1. Check to make sure that batteries are installed correctly in the control.

Step 2. Turn the power off to the fan (from the circuit breaker) for at least 5 seconds.

Step 3. Turn the power back on (at the circuit breaker) and push the Hi, Med, and Low buttons–in that order–within 20 seconds. Step 4. The fan should now function properly.

Circuit breaker

or fuse box

		MED
		2
LO	1	3 HIGH

PRESS IN THIS ORDER TO SET NEW FREQUENCY:

HI MED LO