Wilderness™ 
INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
PERMA•LOCK™ HARDWARE
ALLEN SET SCREW
3mm
allen wrench
|
| 6” downrod |
MOTOR COVER | 6 - 3/8” screw | & Ball assembly |
| (3) |
|
FAN PREPARTION
important safety information!
before starting the installation of your ceiling fan, install the threaded downrod into the motor coupling and lock the assembly
Prepare for fan installation as follows:
Step A. Place the motor cover on the downrod as shown.
Step B. Route the wires from the motor through the Perma•Lock™ downrod and ball assembly.
downrod & ball
assembly
Tip: The downrod has a tapered thread that is designed to lock completely when correctly installed.
Step C. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning, this will take at least four and a half full turns.
Step D. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.
Step E. Slide the motor cover down so that it is flush against the top of the fan.
CAUTION: Failure to fully lock in the down- rod before securely tightening the allen set screw may cause the fan to separate from the downrod during normal operation!
Step F. Using the three screws provided, attach the motor cover to the motor. Tighten firmly by hand only.
tapered thread
MOTOR coupling allen set screw
MOTOR wires
MOTOR COVER
3