BLADE/BLADE HOLDER INSTALLATION
Step 12. Using the blade holder screws(pack of 11) attach each blade/bladeholder assembly to the motor.
Using the screwdriver, tighten securely by hand only.
Blade holder
screws(2 per blade)
SWITCH HOUSING BRACKET/ CAP HARDWARE
|
| switch housing |
| switch housing bracket | mount Screw |
| (removed in step 10) | |
| (2) | |
| ||
|
| |
switch housing cap |
| (2) |
INSTALLING THE SWITCH HOUSING BRACKETS
Step 13. Take the 2 switch housing brackets and snap them into place in the holes in the switch housing. This is to prevent any wires getting pushed down near the motor. Make sure no wires are in the way or pinched in these brackets.
INSTALLING THE SWITCH HOUSING CAP
Note: If you have purchased an accessory light fixture for this fan, please go to Step 16. if not, please continue with
Step 14.
Step 14. Line up the two clearance holes in the cap with the two threaded holes on the raised rim of the switch housing. Press the cap onto the switch housing to seat the guide pins into the alignment holes of the switch housing.
Step 15. Using the two (2)
Tighten securely by hand only.
8