Krell Industries KAV 3250, KAV2250 manual Reconfiguration Options for the KAV-2250 and KAV-3250

Reconfiguration Options for the KAV–2250 and KAV–3250

There are a number of options for reconfiguring the amplifier output:

Multi Amp Throughput (MAT)is an internal connection option for the amplifier that lets

you send the same music signal to all amplifier channels using one balanced or single- ended connection. MAT reduces installation complexity and cabling requirements in systems containing multiple amplifiers.

Bridging	allows you to reconfigure two channels to operate as one combined amplifier
channel. The bridged amplifier channels deliver 1,000 Watts into an 8 Ohm load. The
remaining unbridged amplifier channel on the KAV–3250 can be connected to a
separate loudspeaker.
To reconfigure the amplifier for MAT or for bridged operation you need to remove the
top cover of the amplifier and access the input switch banks.
IMPORTANT
Removing the cover of the amplifier to reconfigure for MAT or for bridged operation is
the ONLY		instance you are authorized to remove the cover of	ANY	Krell component
without voiding your Warranty. For more information on product limitations and
restrictions, see		Warranty, on page 24.

TO SAFELY ACCESS THE INPUT SWITCH BANKS

Before reconfiguring the amplifier, please read the following important instructions to safely remove the amplifier cover and access the input switch banks to reconfigure the KAV–2250 or KAV–3250.

Tool needed: T-15 Torx wrench

1.Unplug the AC power cord from AC power.

2.Krell suggests removing jewelry before reconfiguring your amplifier. Rings, necklaces, bracelets, and other metal jewelry can conduct an electrical charge.

3.Using the T-15 Torx wrench, remove the 12 screws that secure the amplifier cover.

4.Carefully remove the cover.

5.Locate the green input circuit board, which has white input switches and red input switch banks, at the rear of the amplifier

Krell KAV–2250 and KAV–3250 15